Lawn Mower Parts

Shop By Brand Shop By Part Type

Popular Lawn Mower Parts

$4.63
  In Stock
Bearing
Fix Number FIX9006914
Manufacturer Part Number 532009040
This is a premium-quality OEM front wheel flange bearing (sometimes called bushing) commonly used in riding lawn mowers. They are used to keep the wheel held in place securely. It is sold individually but two are needed for each front wheel. It is recommended that they be replaced at the same time. Install this part with the flat side facing the grease zerk in the rear side of the wheel.
$2.99
  Special Order
Ring Klip Number T5304-75
Fix Number FIX9143890
Manufacturer Part Number 812000029
This manufacturer-approved ring clip is found in various lawn and garden equipment models. A ring clip is used as a fastener that secures components or assemblies onto a shaft or housing (such as part of a mower wheel or steering assembly). When it is installed, the part that is visible acts as a shoulder, holding the specific component or assembly together. This very small metal ring clip (approximately 1-inch by 1-inch) is sold individually.
$2.99
  In Stock
Washer 25/32 x 1-1/4 x 16 Ga.
Fix Number FIX9008998
Manufacturer Part Number 532121749
This is a flat metal washer found in various models of lawn mowers and is sold individually. This flat washer can have various functions depending on the equipment; however, its general purpose is to spread the load under a bolt or screw. It also helps to reduce heat and friction as the fastener is tightened. This repair may require a screwdriver or socket wrench, depending on the fastener for your model. This is a single flat washer; the fasteners are sold separately.
$27.83
  In Stock
Mulching Blade
Fix Number FIX9169783
Manufacturer Part Number 942-0741A
This is a mulching blade for your lawn mower. It is located underneath the lawn mower deck, and cuts the grass by rotating. This blade has a curved style shell, and includes extra cutting surfaces along the edges of the blade. If installed correctly this part will keep the grass clipping under the deck longer, and re-cut them. The blade is 21 inches long, and sold individually.
Fixes these symptoms
$2.99
  On Order
Nut-Lock, Ni
Fix Number FIX9276436
Manufacturer Part Number 3296-29
This is a nut, for a variety of outdoor lawn equipment. This part is a nylon insert locking nut, meaning it has a nylon collar insert that makes the nut resistant to turning from heavy vibrations. It is used as part of the shear bolt assembly, as well as other areas in your machine. The nyloc nut has a diameter of roughly a 1/4 inch.
$5.06
  In Stock
Bell Blade Support
Fix Number FIX9119111
Manufacturer Part Number 736-0524B
This is a bell blade support, also known as a bell spacer, for your lawn mower. It is fitted between the bottom of the blade, and the blade bolt. This part provides support for the blade. It is made of metal to ensure a long life. If there is visible damage or wear, replace this part.
Installation Instructions
Michael from Lillian, AL
Blade became warped over time, baffle was falling down
In order to change the blade in a push mower you need to use a 2x4 or equivalent to stop the blade from spinning. I bent the blade back previously by heating it up but I think it was causing too much vibration so I got a new blade after hitting stumps over the years. I run some things into the ground. The spark plug is amazing and really high quality. Its a simple change. The drive belt is also a simple change, any 6 in 1 if you remove the screw heads will have the right nut sizes for most mower parts. Always lube up the belt "like two drops" with a little belt oil and it will last longer. I use diesel oil, 3 n 1, or chain saw bar lube oil. The tensioner for the belt is an easy adjustment. This model is also prone to fuel lines being blocked. Just detach the fuel line, blow it out with your mouth, and reattach. Have had it happen twice in 10 years, some people would be pulling spark plugs, diagnosing the engine, etc, its pretty easy, just put some fuel on the carb to see if your getting fuel blockage. Read more...
$9.27
  In Stock
Bearing-Ball-Mandrel
Fix Number FIX9285698
Manufacturer Part Number 532110485
This is a single mandrel ball bearing for a mower. It is sold individually, however it is a good idea to have a couple of these on hand. This bearing is located on top of the shaft, which is part of the mandrel assembly. The mandrel assembly is bolted to the more deck. This bearing measures roughly 1-3/8-Inches inner diameter, 1.578-Inches outer diameter, and .475-Inches long.
$2.99
  In Stock
Cap Axle Black 1 50 x 1 00
Fix Number FIX9007667
Manufacturer Part Number 532104757
This is an OEM axle cap for lawn tractors and is sold individually. It stops debris from getting into the wheel hub and axle. This axle cap is prone to wear and tear and should be replaced when it is goes missing or appears damaged. No tools are necessary for this easy repair, simply locate the cap axle on the rim of the wheel and remove.
$2.99
  In Stock
Nut-Flange, Ni
Fix Number FIX8827741
Manufacturer Part Number 104-8301
$6.95
  In Stock
Bolt and Washer Assembly
Fix Number FIX9020856
Manufacturer Part Number 532193003
This manufacturer-approved bolt and washer assembly is for lawn tractors. Wear work gloves to protect your hands when installing this part.

Brands

Related Pages

Popular Lawn Mower Models