OEM Ryobi Lawn Mower Parts & Accessories

Mulching Blade

$29.79

Fix Number: FIX9169783
Manufacturer Part Number: 942-0741A

This is a mulching blade for your lawn mower. It is located underneath the lawn mower deck, and cuts the grass by rotating. This blade has a curved style shell, and includes extra cutting surfaces along the edges of the blade. If installed correctly this part will keep the grass clipping under the deck longer, and re-cut them. The blade is 21 inches long, and sold individually.

Fixes these symptoms

Mower blade does not cut
See more...

Nut, Hex, Flangelock

$5.95

Fix Number: FIX9022497
Manufacturer Part Number: 532409149

This is a genuine hex flange locknut for a lawn mower. It attaches to the carriage bolt (sold separately), fastening the axle assembly braces in place. This part is sold individually, however most models require three. For this repair you will need a wrench set.

Watch the install video

Bell Blade Support

$6.15

Fix Number: FIX17016260
Manufacturer Part Number: 736-0524B-1

This is a bell blade support, also known as a bell spacer, for your lawn mower. It is fitted between the bottom of the blade, and the blade bolt. This part provides support for the blade. It is made of metal to ensure a long life. If there is visible damage or wear, replace this part.

Installation Instructions

Michael from Lillian, AL

Blade became warped over time, baffle was falling down

In order to change the blade in a push mower you need to use a 2x4 or equivalent to stop the blade from spinning. I bent the blade back previously by heating it up but I think it was causing too much vibration so I got a new blade after hitting stumps over the years. I run some things into the ground. The spark plug is amazing and really high quality. Its a simple change. The drive belt is also a simple change, any 6 in 1 if you remove the screw heads will have the right nut sizes for most mower parts. Always lube up the belt "like two drops" with a little belt oil and it will last longer. I use diesel oil, 3 n 1, or chain saw bar lube oil. The tensioner for the belt is an easy adjustment. This model is also prone to fuel lines being blocked. Just detach the fuel line, blow it out with your mouth, and reattach. Have had it happen twice in 10 years, some people would be pulling spark plugs, diagnosing the engine, etc, its pretty easy, just put some fuel on the carb to see if your getting fuel blockage. Read more...

Bolt, Handle

$6.35

Fix Number: FIX9014802
Manufacturer Part Number: 532191574

Handle Knob

$5.95

Fix Number: FIX9020379
Manufacturer Part Number: 532185577

This is an OEM part sourced directly from Husqvarna. This handle knob is used on a variety of lawn and garden equipment. Commonly used in lawn mower to secure the handle, and in snow blowers to secure and adjust the angle of the chute. We do recommend that you refer to model specific diagrams for appropriate uses and applications. This handle knob is made of plastic and it is sold individually.

Spring-Extension

$5.07

★★★★★

1 Review

Fix Number: FIX9310931
Manufacturer Part Number: 932-0264

Installation Instructions

Leonard from South Hadley, MA

Drive would Slip in and out then unable to engage traction control.

Removed frame cover. Found broken Idler Spring. This is what cause the slipping and clunking noise. also check or replaced as I did.t The Extension Spring is a little harder to get to. With the idler spring broken this cause the friction wheel and support bracket to break the Drive Clutch Cable Spring and Support Bracket Spring. Easy to replace. At this time clean and oil the part called 7-tooth shaft. This helped shifting speeds. Be careful not to get any oil on the friction wheel or the friction disc. FYI Problems like this will always happen at the wrong time. The web site easy to use but the illustrations and part numbers could be better to read. Need to have clearer zoom and part number to part. Not sure part name like spring-extension or extension-spring. So I purchased both parts. This snow blower easy to use and repair. A simple design. Read more...

Rear Skirt

$13.69

Fix Number: FIX9287254
Manufacturer Part Number: 532413160

Lawn Mower Zone Control Cable

$18.44

Fix Number: FIX9180334
Manufacturer Part Number: 946-1130

This zone control cable is for lawn mowers. Zone control cable stops the engine when you let go of the handle. Wear work gloves to protect your hands during this repair.

Fixes these symptoms

Will Not Start
See more...

Installation Instructions

Joseph from San Jose, CA

Broken control cable and handle

Really straight forward, can be done without tools. Great price for parts and job done for less that half of what it would cost to have a shop do it. Even a lazy teenagers can do it....:) mine did:) Read more...

Blade Adapter

$22.04

Fix Number: FIX10008037
Manufacturer Part Number: 748-0376E

Washer-Lock 5/16

$4.95

Fix Number: FIX9311087
Manufacturer Part Number: 936-0119

This lock washer is used to resist the loosening of bolted joints. Repair tip: It is difficult to install the lock washer in a tight place or when the bolt/screw is pointing down. This lock works with the following appliances: Lawn tractor, tiller, chipper, shredder, lawn mower, snow blower, leaf blower/vacuum, log splitter, edger, hedge trimmer, and engine. Refer to the manual provided by the manufacturer for repair instructions.

Ryobi Lawn Mower Parts

Popular Ryobi Lawn Mower Parts

Installation Instructions

Installation Instructions

Installation Instructions

Ryobi Lawn Mower Appliance Types

Popular Ryobi Lawn Mower Models

Ryobi Lawn Mower Parts

Start With Your Model Number

Popular Ryobi Lawn Mower Parts

Installation Instructions

Installation Instructions

Installation Instructions

Ryobi Lawn Mower Appliance Types

Popular Ryobi Lawn Mower Models