OEM Poulan Parts | Expert DIY Repair Help & Fast Shipping

$4.78

Engine Fuel Filter

Fix Number FIX9285148

Manufacturer Part Number 530095646

This fuel filter is for lawn and garden equipment engines. Fuel filter cleans the fuel before it reaches the carburetor. Work in a well-ventilated area when installing this part. Drain the fuel tank and disconnect the spark plug wire before beginning the repair.

Fixes these symptoms

Engine stops after a few seconds or minutes
Will Not Start
See more...

Installation Instructions

Aaron from BALTIC, OH

Wouldn’t start

Replaced fuel line and filter. Also replaced diaphragms, screens, float, needle and gaskets. It then started but wouldn’t keep running. I had to back out fuel air mix needle completely and spray carb cleaner in these holes. It then ran perfectly. Make sure you count the rounds they are backed off before removing. Read more...

$5.97

Fuel Line

★★★★★

1 Review

Fix Number FIX9472280

Manufacturer Part Number 530069247

This chainsaw fuel line kit carries fuel from the tank into the carburetor and from the primer bulb to the fuel system. This part is mostly used on gas trimmers and blowers. The fuel lines are made from clear, flexible, and rubber material. In time, this part can begin to deteriorate, which can result in leaks. To prevent this, make sure to replace the fuel line. As a safety precaution, remember to wear work gloves to protect your hands during repair.

Fixes these symptoms

Engine stops after a few seconds or minutes
Will Not Start
See more...

Installation Instructions

Larry from Sanford, NC

fuel line is very tight going on

Using forceps, hold tight grip on fuel line about only 1/8 of an inch back of end and lube lightly. Push slowly and work onto nipple. Read more...

$5.97

Tank Purge Line

Fix Number FIX9472264

Manufacturer Part Number 530069216

This is a tank purge line, also known as a fuel line kit, and it is used with various lawn equipment. The line connects fuel from the tank into the carburetor, and from the primer bulb back into the fuel system. The extra fuel is forced through the line into the fuel tank. This tube is transparent, and has a diameter of 3/16 inches. Before making this repair, we recommend draining the fuel from your machine, and removing the spark plug.

Fixes these symptoms

Will Not Start
See more...

$3.58

Washer 25/32 x 1-1/4 x 16 Ga.

Fix Number FIX9008998

Manufacturer Part Number 532121749

This is a flat metal washer found in various models of lawn mowers and is sold individually. This flat washer can have various functions depending on the equipment; however, its general purpose is to spread the load under a bolt or screw. It also helps to reduce heat and friction as the fastener is tightened. This repair may require a screwdriver or socket wrench, depending on the fastener for your model. This is a single flat washer; the fasteners are sold separately.

$5.97

Bearing

Fix Number FIX9006914

Manufacturer Part Number 532009040

This is a premium-quality OEM front wheel flange bearing (sometimes called bushing) commonly used in riding lawn mowers. They are used to keep the wheel held in place securely. It is sold individually but two are needed for each front wheel. It is recommended that they be replaced at the same time. Install this part with the flat side facing the grease zerk in the rear side of the wheel.

$3.58

Ring Klip Number T5304-75

Fix Number FIX9143890

Manufacturer Part Number 812000029

This manufacturer-approved ring clip is found in various lawn and garden equipment models. A ring clip is used as a fastener that secures components or assemblies onto a shaft or housing (such as part of a mower wheel or steering assembly). When it is installed, the part that is visible acts as a shoulder, holding the specific component or assembly together. This very small metal ring clip (approximately 1-inch by 1-inch) is sold individually.

$46.68

Lawn Tractor Mandrel Assembly

★★★★★

1 Review

Fix Number FIX12087499

Manufacturer Part Number 587819701

Installation Instructions

Terrence from LORENA, TX

Blade mandrel replacement

1. Remove mower deck.
2. Remove mower blade from defective mandrel.
3. Clean caked up grass from underside of mower deck.
4. Remove belt pulley from top of defective mandrel.
5. Remove four bolts fastening defective mandrel to deck. Note: bolts will most likely shear - make sure you have new ones.
6. Install new mandrel to deck using four new self-tapping bolts.
7. Reinstall mower blade to new mandrel assembly.
8. Reinstall belt pulley to new mandrel assembly.
9. Reinstall mower deck to tractor. Read more...

$3.58

Cap Axle Black 1 50 x 1 00

Fix Number FIX9007667

Manufacturer Part Number 532104757

This is an OEM axle cap for lawn tractors and is sold individually. It stops debris from getting into the wheel hub and axle. This axle cap is prone to wear and tear and should be replaced when it is goes missing or appears damaged. No tools are necessary for this easy repair, simply locate the cap axle on the rim of the wheel and remove.

$4.78

Foam-Air Filter

Fix Number FIX9470926

Manufacturer Part Number 530037793

This is a foam air filter for small engines, used in various types of outdoor lawn and garden equipment. This genuinely sourced air filter is sold individually. This is a very important part to add to your regular maintenance checklist. The filter prevents dust and dirt from reaching the carburetor and engine and is essential to the smooth and efficient operation of your equipment. This is an easy replacement, that should only take a short amount of time to complete. You may need a nut driver, a pair of pliers, screwdrivers, and a socket. This air filter is compatible with multiple models, so exact repair instruction may differ.

$8.37

Primer Bulb Kit

Fix Number FIX9472698

Manufacturer Part Number 530071835

This is a single OEM purge bulb, also sometimes referred to as a primer bulb. It is usually located close to the starter rope. By pressing down on the purge bulb, this forces fuel into the fuel line from the fuel tank and into the carburetor to help get the engine started. Due to its constant contact with fuel, the bulb is prone to damage over time and will need to be replaced.

Fixes these symptoms

Will Not Start
See more...

Installation Instructions

Larry from Sanford, NC

fuel line is very tight going on

Using forceps, hold tight grip on fuel line about only 1/8 of an inch back of end and lube lightly. Push slowly and work onto nipple. Read more...

Poulan Parts

Popular Poulan Parts

Appliance Type

Popular Poulan Models

Poulan Parts

Start With Your Model Number

Popular Poulan Parts

Appliance Type

Popular Poulan Models