Leaf Blower / Vacuum Parts
Start With Your Model Number
Popular Leaf Blower / Vacuum Parts
Lawn Mower Ground Drive Belt
Fix Number FIX9172714
Manufacturer Part Number 954-04032BThis is a drive belt and it is used on various outdoor lawn equipment. This part is made of rubber and is sold individually. It measures to be 35.80 inches by 0.5 inches. This part drives the transmission, which propels the wheels on your machine. Pro tip, clean off the pulleys before installing this part for a longer lifespan. We recommend inspecting your belt periodically as they wear out quickly, depending on usage.
Spark Plug Bpm-8Y
Fix Number FIX9263506
Manufacturer Part Number 15901019830Replacing the spark plug should be part of your regular maintenance. How often to replace it depends on your model but is generally changed at least once a year or more depending on use. When a spark plug has gone bad this can lead to a hard starting engine, a misfire, or the engine not starting at all. Replacing it is very easy, start by gapping your new spark plug according to the manufacturer specifications. For this repair, start by removing the boot from the old plug, use a wrench to remove it, and twist it off with your hand. Now thread the new replacement spark plug into place and tighten it using the wrench. This manufacturer-approved spark plug is sold individually.
Fix Number FIX9311087
Manufacturer Part Number 936-0119This lock washer is used to resist the loosening of bolted joints. Repair tip: It is difficult to install the lock washer in a tight place or when the bolt/screw is pointing down. This lock works with the following appliances: Lawn tractor, tiller, chipper, shredder, lawn mower, snow blower, leaf blower/vacuum, log splitter, edger, hedge trimmer, and engine. Refer to the manual provided by the manufacturer for repair instructions.
Hex Nut 5/16-18
Fix Number FIX9309225
Manufacturer Part Number 912-3010This is a hex nut, and it is found on various outdoor lawn equipment. The hex nut is the most commonly used fastener. This part has internal threads used to screw on to a bolt, or a hex cap screw. The measurement of this part is 0.3125 inches in diameter, with an 18 thread count.
Fuel Tank Vent
Fix Number FIX9183121
Manufacturer Part Number A356000031This check valve or the fuel tank vent is connected to the fuel tank in the following products: hedge trimmer, leaf blower/vacuum, chainsaw, edger, engine, tiler, auger, water pump, chipper shredder, sprayer, and brush cutter. The check valve allows air into the fuel tank to prevent vacuum when the fuel is being fed through the fuel line. Tip: if the vent is clogged, your engine may stall. Usually, the vent line is connected to a fuel grommet that is installed on the fuel tank. The tools needed for this installation are: needle-nose pliers and a small slotted screwdriver. Remember to wear work gloves to protect hands. Refer to the manual for an accurate repair guide.
Engine Fuel Filter
Fix Number FIX9285148
Manufacturer Part Number 530095646This fuel filter is for lawn and garden equipment engines. Fuel filter cleans the fuel before it reaches the carburetor. Work in a well-ventilated area when installing this part. Drain the fuel tank and disconnect the spark plug wire before beginning the repair.
Fixes these symptoms
- Will Not Start
- See more...
Aaron from BALTIC, OH
Wouldn’t startReplaced fuel line and filter. Also replaced diaphragms, screens, float, needle and gaskets. It then started but wouldn’t keep running. I had to back out fuel air mix needle completely and spray carb cleaner in these holes. It then ran perfectly. Make sure you count the rounds they are backed off before removing. Read more...
Fix Number FIX9472280
Manufacturer Part Number 530069247This chainsaw fuel line kit carries fuel from the tank into the carburetor and from the primer bulb to the fuel system. This part is mostly used on gas trimmers and blowers. The fuel lines are made from clear, flexible, and rubber material. In time, this part can begin to deteriorate, which can result in leaks. To prevent this, make sure to replace the fuel line. As a safety precaution, remember to wear work gloves to protect your hands during repair.
Fixes these symptoms
- Engine stops after a few seconds or minutes
- Will Not Start
- See more...
Larry from Sanford, NC
fuel line is very tight going onUsing forceps, hold tight grip on fuel line about only 1/8 of an inch back of end and lube lightly. Push slowly and work onto nipple. Read more...
Fix Number FIX9276436
Manufacturer Part Number 3296-29This is a nut, for a variety of outdoor lawn equipment. This part is a nylon insert locking nut, meaning it has a nylon collar insert that makes the nut resistant to turning from heavy vibrations. It is used as part of the shear bolt assembly, as well as other areas in your machine. The nyloc nut has a diameter of roughly a 1/4 inch.
Bell. Wash. .340 I.D. x .872 O.D.
Fix Number FIX10006541
Manufacturer Part Number 736-0242This is a Belleville washer, and it is used with various lawn and garden equipment around your home. This part has an inner diameter of 0.340 inches and an outer diameter of 0.872 inches. The convex shape of the Belleville washer acts like a spring, which is why they are often used in high load bearing situations.