Leaf Blower / Vacuum Hardware

Fuel Line Grommet This is a fuel line grommet, and it is used with various lawn and garden equipment. This part prevents leaking fuel and fumes. The grommet is placed in the fuel tank to seal the opening area where the fuel line and the fuel tank connect. A worn grommet is a safety hazard because it will cause fuel to leak from the tank. We recommend when replacing it to also replace the fuel line. Before starting this repair make sure to drain the fuel from the tank, and remove the spark plug.

Return Grommet This is a return grommet for your lawn and garden equipment. This part creates an airtight seal to prevent fuel leaking from your machine. We recommend installing both the grommet and the return fuel line together. Place the return fuel line inside the grommet and install both into the fuel tank.

Clip

Clip This is a clip for a variety of lawn and garden equipment. The clip is made of a durable metal, and is 6.5mm in diameter. This part is most commonly used to clamp tubes and hoses in place. The clip is sold individually.

Washer

Wing Bolt

Retainer Cushion This is an authentic OEM retainer cushion, sold independently. The retainer cushion is an isolator mount that secures the blowers fan housing and engine to the backpack frame. It consists of two steel plates that are attached to a rubber isolator. The isolator helps to limit the vibration from the harness. This rubber isolator component can deteriorate over time and will fail, requiring replacement. To access this part, start by removing the nut that secures the retainer cushion to the frame. Then remove the screws that secure the intake shroud to the frame. This will allow you to remove the blower housing and motor away from the frame. Remove the retainer strap from the stud on the isolator and the two screws that secure it to the blower housing. The new retainer can now be installed.

Key-Flywheel

Nut 5 This nut is used for a variety of handheld gardening tools. The nut has multiple applications depending on the tool you are using. Refer to the diagram provided by the manufacturer for installation instructions and nut location in a specific tool. This lock nut is used to resist loosening when threaded onto a bolt. *Please note: this part is sold individually. The measurements are: 5mm.

Cushion