Paramount Leaf Blower / Vacuum Parts

This fuel filter (part number 530095646) is for lawn and garden equipment engines. Fuel filter 530095646 cleans the fuel before it reaches the carburetor. Work in a well-ventilated area when installing this part. Drain the fuel tank and disconnect the spark plug wire before beginning the repair.

This chainsaw fuel line kit carries fuel from the tank into the carburetor and from the primer bulb to the fuel system. This part is mostly used on gas trimmers and blowers. The fuel lines are made from clear, flexible, and rubber material. In time, this part can begin to deteriorate, which can result in leaks. To prevent this, make sure to replace the fuel line. As a safety precaution, remember to wear work gloves to protect your hands during repair.

This is a spark plug and it is used on various lawn equipment around your home. This part powers the engine by lighting the fuel and air mixture found in the cylinder of the engine. If the tip of the spark plug is damaged or burnt (also known as fouled), the engine will not start. This spark plug is Rcj7-8Y, that means this has a resistor type R, a shell design type CJ (14mm thread, 0.375 inch reach, 0.75 or 0.8125 inch hex), a heat range/application type 7-8 (heat range with automotive, small engine, and ordnance applications), and a firing end design of type Y (standard projected core nose). If your machine is not turning on, or is running extremely rough, you will need to replace the spark plug.

This is a 3ft rope for a variety of power tools, most commonly chainsaws. It twists around the pulley of the recoil starter, which will allow you to pull-start the engine. This part is made of a durable nylon, but over time may wear out and snap. When that happens, you will need to replace it. Take note the plastic grip is sold separately.

This is a carburetor repair kit, but it may also be known as a carburetor gasket or diaphragm kit, for your lawn equipment. This assembly is used to replace the gaskets in your machine. If you are having problems with your carburetor, this kit most likely takes care of it. Note: The beige piece pictured has been redesigned. It no longer has the 4 corner holes. It now only has 2 corner holes at a diagonal. To replace these items, you will need a screwdriver and pliers.