Lawn Tractor Parts

Popular Lawn Tractor Parts

Snow Blower Bow Tie Cotter Pin
$3.99
In Stock
Fix Number
FIX9096195
Manufacturer Part Number
714-04040
This bow tie cotter pin fits snow blowers, as well as other gardening tools. The pin helps secure the auger to the shaft on a snow blower. Due to constant wear, this is a commonly replaced part. Tip: Extra pins are recommended. *Please note: this part is sold individually. For installation instructions, refer to the diagram provided by the manufacturer.
Lawn Tractor Mandrel Assembly
$58.37
In Stock
★★★★★
★★★★★
1 Review
Fix Number
FIX12087499
Manufacturer Part Number
587819701

Installation Instructions

Terrence from LORENA, TX
Blade mandrel replacement
1. Remove mower deck.
2. Remove mower blade from defective mandrel.
3. Clean caked up grass from underside of mower deck.
4. Remove belt pulley from top of defective mandrel.
5. Remove four bolts fastening defective mandrel to deck. Note: bolts will most likely shear - make sure you have new ones.
6. Install new mandrel to deck using four new self-tapping bolts.
7. Reinstall mower blade to new mandrel assembly.
8. Reinstall belt pulley to new mandrel assembly.
9. Reinstall mower deck to tractor.
Read more...
Lawn Mower Flange Wheel Bearing
$9.18
In Stock
Fix Number
FIX9006914
Manufacturer Part Number
532009040
This is a premium-quality OEM front wheel flange bearing (sometimes called bushing) commonly used in riding lawn mowers. They are used to keep the wheel held in place securely. It is sold individually but two are needed for each front wheel. It is recommended that they be replaced at the same time. Install this part with the flat side facing the grease zerk in the rear side of the wheel.
Lawn Mower Hex Head Bolt
$3.99
In Stock
Fix Number
FIX9982804
Manufacturer Part Number
584953901
This part is the replacement washer head screw for your lawn tractor. It is black in color and is approximately an inch and a half in length. This self-threading screw is most commonly used for securing the mandrel housing to the mower deck of your lawn tractor. The main reason you would need to replace this part is if the old screw is damaged or missing. This part is sold individually and is a genuine OEM part sourced directly from the manufacturer.
Lawn Mower Axle Hub Cap
$5.95
In Stock
Fix Number
FIX9007667
Manufacturer Part Number
532104757
This is an OEM axle cap for lawn tractors and is sold individually. It stops debris from getting into the wheel hub and axle. This axle cap is prone to wear and tear and should be replaced when it is goes missing or appears damaged. No tools are necessary for this easy repair, simply locate the cap axle on the rim of the wheel and remove.
Lawn Mower Ring Clip
$5.95
In Stock
Fix Number
FIX9143890
Manufacturer Part Number
812000029
This manufacturer-approved ring clip is found in various lawn and garden equipment models. A ring clip is used as a fastener that secures components or assemblies onto a shaft or housing (such as part of a mower wheel or steering assembly). When it is installed, the part that is visible acts as a shoulder, holding the specific component or assembly together. This very small metal ring clip (approximately 1-inch by 1-inch) is sold individually.
Lawn Mower Wheel
$9.54
In Stock
Fix Number
FIX12630280
Manufacturer Part Number
589527301
This genuine Craftsman hex gauge wheel is a replacement part sourced directly from the original manufacturer and is designed for use with riding lawn mowers. It attaches to the mower’s deck assembly and helps support the deck while providing traction, preventing it from making direct contact with the ground during operation. This helps maintain an even cut and protects both the deck and the lawn. The gauge wheel is sold individually, so be sure to check your model’s specifications to determine the quantity needed.
Snow Blower Locking Flange Nut
$5.95
In Stock
Fix Number
FIX9092936
Manufacturer Part Number
712-04063
This nut is fit for lawn and garden equipment and is used to resist loosening when properly threaded onto a bolt. The nut is sold individually. The diameter of the nut is 5/16 inches and the thread size is 18. Refer to the manual provided by the manufacturer for repair instructions.

Installation Instructions

Ronald from SPEARFISH, SD
Replace sheave plate and side skid shoes on snowblower.
Remove eight bolts and two skid shoes and bottom sheave plate. Replace in reverse order.
Most important, get the correct OEM parts from FIX.com. Refer to product parts list in model instruction manual.
Do that first and you too can see how easy this repair is and save big bucks charged by retail repair shop!
Read more...
Snow Blower Carriage Bolt
$5.02
Special Order
Fix Number
FIX10001568
Manufacturer Part Number
710-0451
This carriage bolt fits a variety of tools and is sold individually. The square area under the head of the bolt is created to fit into a square hole in your tool. The hole makes sure to restrain the bolt and prevents it from turning when the nut is secured or tightened.

Installation Instructions

Ronald from SPEARFISH, SD
Replace sheave plate and side skid shoes on snowblower.
Remove eight bolts and two skid shoes and bottom sheave plate. Replace in reverse order.
Most important, get the correct OEM parts from FIX.com. Refer to product parts list in model instruction manual.
Do that first and you too can see how easy this repair is and save big bucks charged by retail repair shop!
Read more...
Lawn Mower Washer
$3.99
On Order
Fix Number
FIX9008998
Manufacturer Part Number
532121749
This is a flat metal washer found in various models of lawn mowers and is sold individually. This flat washer can have various functions depending on the equipment; however, its general purpose is to spread the load under a bolt or screw. It also helps to reduce heat and friction as the fastener is tightened. This repair may require a screwdriver or socket wrench, depending on the fastener for your model. This is a single flat washer; the fasteners are sold separately.

Lawn Tractor Brands

Related Lawn Tractor Parts

Popular Lawn Tractor Models