OEM Husqvarna Lawn Tractor Parts | Expert DIY Repair Help & Fast Shipping

$6.36

Bearing

Fix Number FIX9006914

Manufacturer Part Number 532009040

This is a premium-quality OEM front wheel flange bearing (sometimes called bushing) commonly used in riding lawn mowers. They are used to keep the wheel held in place securely. It is sold individually but two are needed for each front wheel. It is recommended that they be replaced at the same time. Install this part with the flat side facing the grease zerk in the rear side of the wheel.

$3.81

Washer 25/32 x 1-1/4 x 16 Ga.

Fix Number FIX9008998

Manufacturer Part Number 532121749

This is a flat metal washer found in various models of lawn mowers and is sold individually. This flat washer can have various functions depending on the equipment; however, its general purpose is to spread the load under a bolt or screw. It also helps to reduce heat and friction as the fastener is tightened. This repair may require a screwdriver or socket wrench, depending on the fastener for your model. This is a single flat washer; the fasteners are sold separately.

$3.81

Ring Klip Number T5304-75

Fix Number FIX9143890

Manufacturer Part Number 812000029

This manufacturer-approved ring clip is found in various lawn and garden equipment models. A ring clip is used as a fastener that secures components or assemblies onto a shaft or housing (such as part of a mower wheel or steering assembly). When it is installed, the part that is visible acts as a shoulder, holding the specific component or assembly together. This very small metal ring clip (approximately 1-inch by 1-inch) is sold individually.

$5.09

Nut, Hex, Flangelock

Fix Number FIX9022497

Manufacturer Part Number 532409149

This is a genuine hex flange locknut for a lawn mower. It attaches to the carriage bolt (sold separately), fastening the axle assembly braces in place. This part is sold individually, however most models require three. For this repair you will need a wrench set.

$3.81

Cap Axle Black 1 50 x 1 00

Fix Number FIX9007667

Manufacturer Part Number 532104757

This is an OEM axle cap for lawn tractors and is sold individually. It stops debris from getting into the wheel hub and axle. This axle cap is prone to wear and tear and should be replaced when it is goes missing or appears damaged. No tools are necessary for this easy repair, simply locate the cap axle on the rim of the wheel and remove.

$3.81

Washer 25/32 x 1-5/8 x 16 Ga.

Fix Number FIX9012535

Manufacturer Part Number 532121748

This part includes one genuinely sourced washer for a ride-on lawn mower. Washers help to disperse the load and provides a tight seal in between components. Depending on your unit, the applications will vary. This metal washer measures approximately 25/32 by 1-5/8 by 16 Ga. You may require a wrench to complete this repair.

$49.71

Lawn Tractor Mandrel Assembly

★★★★★

(1)

Fix Number FIX12087499

Manufacturer Part Number 587819701

Installation Instructions

Terrence from LORENA, TX

Blade mandrel replacement

1. Remove mower deck.
2. Remove mower blade from defective mandrel.
3. Clean caked up grass from underside of mower deck.
4. Remove belt pulley from top of defective mandrel.
5. Remove four bolts fastening defective mandrel to deck. Note: bolts will most likely shear - make sure you have new ones.
6. Install new mandrel to deck using four new self-tapping bolts.
7. Reinstall mower blade to new mandrel assembly.
8. Reinstall belt pulley to new mandrel assembly.
9. Reinstall mower deck to tractor. Read more...

$3.81

Washer-Spacer

Fix Number FIX9286886

Manufacturer Part Number 532187690

This is an OEM lawn mower deck mandrel spacer washer, sold individually. It measures approximately 43/64-Inches in diameter, 1-1/8-Inches outer diameter, and 5/32-Inches thick (these measurements are approximate). In general, washers help to spread load, can provide insulation such as electrical, and can also help to prevent galvanic corrosion.

$8.91

Bolt and Washer Assembly

Fix Number FIX9020856

Manufacturer Part Number 532193003

This manufacturer-approved bolt and washer assembly is for lawn tractors. Wear work gloves to protect your hands when installing this part.

$11.46

Bearing-Ball-Mandrel

Fix Number FIX9285698

Manufacturer Part Number 532110485

This is a single mandrel ball bearing for a mower. It is sold individually, however it is a good idea to have a couple of these on hand. This bearing is located on top of the shaft, which is part of the mandrel assembly. The mandrel assembly is bolted to the more deck. This bearing measures roughly 1-3/8-Inches inner diameter, 1.578-Inches outer diameter, and .475-Inches long.

Husqvarna Lawn Tractor Parts

Popular Husqvarna Lawn Tractor Parts

Appliance Type

Related Pages

Popular Husqvarna Lawn Tractor Models

Husqvarna Lawn Tractor Parts

Start With Your Model Number

Popular Husqvarna Lawn Tractor Parts

Appliance Type

Related Pages

Popular Husqvarna Lawn Tractor Models