Ryobi Lawn Tractor Parts

Fix Number

FIX9006914

Manufacturer Part Number

532009040

This is a premium-quality OEM front wheel flange bearing (sometimes called bushing) commonly used in riding lawn mowers. They are used to keep the wheel held in place securely. It is sold individually but two are needed for each front wheel. It is recommended that they be replaced at the same time. Install this part with the flat side facing the grease zerk in the rear side of the wheel.

Fix Number

FIX9007667

Manufacturer Part Number

532104757

This is an OEM axle cap for lawn tractors and is sold individually. It stops debris from getting into the wheel hub and axle. This axle cap is prone to wear and tear and should be replaced when it is goes missing or appears damaged. No tools are necessary for this easy repair, simply locate the cap axle on the rim of the wheel and remove.

Fix Number

FIX9143890

Manufacturer Part Number

812000029

This manufacturer-approved ring clip is found in various lawn and garden equipment models. A ring clip is used as a fastener that secures components or assemblies onto a shaft or housing (such as part of a mower wheel or steering assembly). When it is installed, the part that is visible acts as a shoulder, holding the specific component or assembly together. This very small metal ring clip (approximately 1-inch by 1-inch) is sold individually.

Fix Number

FIX9020864

Manufacturer Part Number

532193350

This ignition switch has been sourced directly from the original manufacturer and is sold individually (key sold separately). The ignition switch is also sometimes referred to as a starter switch and is enclosed in a plastic housing. A common sign that this part is malfunctioning is if the electric starter is not engaging. For this quick and easy repair, start by making sure the switch is in the off position and the key has been removed. Lift the hood up, locate the steering housing and press the tabs to disengage the old switch. Disconnect the wires and install your new OEM ignition switch.

Fix Number

FIX9008998

Manufacturer Part Number

532121749

This is a flat metal washer found in various models of lawn mowers and is sold individually. This flat washer can have various functions depending on the equipment; however, its general purpose is to spread the load under a bolt or screw. It also helps to reduce heat and friction as the fastener is tightened. This repair may require a screwdriver or socket wrench, depending on the fastener for your model. This is a single flat washer; the fasteners are sold separately.

Fix Number

FIX9022497

Manufacturer Part Number

532409149

This is a genuine hex flange locknut for a lawn mower. It attaches to the carriage bolt (sold separately), fastening the axle assembly braces in place. This part is sold individually, however most models require three. For this repair you will need a wrench set.

★★★★★

★★★★★

1 Review

Fix Number

FIX9286056

Manufacturer Part Number

532138971

This replacement blade is supplied directly from the original equipment manufacturer for use with Craftsman riding lawn mowers and garden tractors. It is secured under the deck to cut the grass, over time the blade may become dull or damaged causing irregular cutting patterns. Inspect your blades periodically and replace them as needed to maintain a clean cut lawn. It is a high-quality component which is made of durable steel and it is sold individually.

Fix Number

FIX9286886

Manufacturer Part Number

532187690

This is an OEM lawn mower deck mandrel spacer washer, sold individually. It measures approximately 43/64-Inches in diameter, 1-1/8-Inches outer diameter, and 5/32-Inches thick (these measurements are approximate). In general, washers help to spread load, can provide insulation such as electrical, and can also help to prevent galvanic corrosion.

Fix Number

FIX9167515

Manufacturer Part Number

941-0475

This is a plastic bushing for your lawn equipment. It fits onto the side of your fuel tank, and holds the fuel fittings so they do not touch sharp metal. This part is made of plastic, and will eventually wear out. When that happens, you must replace it. Before making this repair, we recommend letting your machine cool, and draining the gas tank.

Fix Number

FIX9015920

Manufacturer Part Number

532188967