Hardwick Parts

★★★★★

★★★★★

3 Reviews

Fix Number

FIX2376034

Manufacturer Part Number

8206232A

To access the exterior lightbulb, the bottom panel of the microwave will need to be removed. It is secured in place with screws, so will require a Philips screwdriver to remove it. Screw the new light bulb directly into the light socket. If this is the first time you have replaced this light bulb, the old light bulb might be held in place with silicone. This silicone will need to be cut off using either a utility knife or dental floss before removing the light bulb. Once this silicone and old bulb has been removed, the replacement bulb can be screwed in its place.

★★★★★

★★★★★

4 Reviews

Fix Number

FIX11722130

Manufacturer Part Number

EDR4RXD1

This package contains one individual water filter that is NSF-certified, and OEM approved. To ensure that the filter is successfully removing contaminants, it will need to be replaced at least every 6 months or 200 gallons of water. This will ensure tasteless and odor-free water. It has approximate measurements of 2-1/2 inches deep, 1-1/2 inches wide, and 8 inches high. This is a simple installation. This filter is found on the interior of the refrigerator in a drop-down style housing. Pop out the old filter, slide the new filter in place and turn it until it clicks. Be careful not to over-tighten. Close the cover. Run your dispenser to activate the filter and clear out air bubbles. A loud air pressure sound is completely normal. Reset your water filter indicator if applicable.

★★★★★

★★★★★

1 Review

Fix Number

FIX11750107

Manufacturer Part Number

WPW10196405

This chrome drip bowl is an OEM approved replacement part sourced directly from the manufacturer. Drip bowls are a part for your cooktop, positioned underneath the burner to catch spills. This drip bowl fits under 8-inch burner elements and has a diameter of approximately 10-inches. It is common for the manufacturer to switch up designs, so it may not match your current part, however searching using the correct model number will ensure proper fit and function. Drips bowls are prone to wear and tear and can be a fire hazard if not replaced when needed. It is also a quick, easy, and cheap way to give your appliance a fresh new look. Each drip bowl is sold individually, so if you are interested in replacing your other drips bowls, they need to be ordered separately. This is also an opportune time to inspect the terminals for corrosion or damage, and the condition of the burner. No tools are required for installation, simply line up the hole on the bowl with the terminal block and drop it into place. Give your new drip bowl a regular cleaning with warm water and soap to help it last as long as possible.

★★★★★

★★★★★

4 Reviews

Fix Number

FIX11750108

Manufacturer Part Number

WPW10196406

This chrome drip bowl is an OEM approved replacement part designed for use with various models of electric ranges and cooktops. This drip bowl fits under 6-inch burner elements and has a diameter of approximately 8 inches. It sits under the burner, keeping any drips and spill contained. It is common for this part to become discolored, corroded, or otherwise damaged with time, and will need to be replaced. Each drip bowl is sold individually, so this is a good time to check the other drip bowls on the appliance in case you would like to replace those as well (sold separately). No tools are required for installation, simply line up the hole on the bowl with the terminal block and drop it into place. By routinely cleaning this part, it will help to prolong its life.

★★★★★

★★★★★

2 Reviews

Fix Number

FIX884734

Manufacturer Part Number

8009

This is a genuine OEM 40-Watt replacement light bulb that is compatible with various types of appliances. It has a frosted glass bulb with a standard metal socket base, making it easy to screw and unscrew by hand to replace. It is designed to tolerate extreme temperatures, which is why it is commonly used to light the inside of refrigerators and ovens. Depending on the appliance and location of the bulb, disconnecting the power is recommended. This bulb is sold individually.

★★★★★

★★★★★

3 Reviews

Fix Number

FIX12728638

Manufacturer Part Number

W11384469

Door switch turns the light off when you close the door.

★★★★★

★★★★★

3 Reviews

Fix Number

FIX11723190

Manufacturer Part Number

W10827015

This genuine OEM part is a door cover for your refrigerator pantry drawer. It helps to maintain the proper temperature and humidity in the drawer by providing a seal when closed. Other names for this part include pantry drawer door or pantry drawer cover. No tools are required to replace this part. Simply release the locking tab and pull out the old cover one end at a time. Insert the new door cover, making sure the holes are properly secured around the hinge pins. The door cover should now open and close easily. To prevent damage to the new door cover, make sure that the snack drawer is fully pushed back into place before closing the cover, so that it can lay flat on the drawer.

★★★★★

★★★★★

2 Reviews

Fix Number

FIX2366565

Manufacturer Part Number

W10196406RW

The drip bowl is used for electric ranges or cooktops with the coiled style burners, to catch any drips, spills, or crumbs that may occur while cooking. If your bowls have become discolored, corroded, difficult to clean, or otherwise damaged it may be time to replace them. This repair is easy and does not require any tools to complete the job. Ensure that all burners are turned off and cool to the touch before starting. First you need to lift up and disconnect the burner from the socket. While you have the burner out, it is a good time to check it for any signs of damage. Look at the terminals for any signs of arcing or burning. If you notice this, you will want to replace both the element and the receptacle it plugs into. Remove the old drip bowl by pulling it out. Then insert the new one by lining up the small hole on the side with the element block. Ensure that it is siting flat and then plug the element back into the socket. Please note that the manufacturer has substituted this part, and it no longer has a solid bottom. It is not recommended to cover the hole with products like aluminum foil, as it can trap heat or melt, becoming a fire hazard. As it is an OEM part, it ensures it will fit your model. The drip bowls are sold individually, chrome in color and about 8 inches in diameter, made to fit under a 6 inch burner element.

★★★★★

★★★★★

2 Reviews

Fix Number

FIX2121513

Manufacturer Part Number

D7824706Q

If your freezer has stopped making ice cubes, it may be time to replace your ice maker. Normal wear and tear, or accidental damage may be the cause of this. This model includes the control device and ice mold, which are made of plastic and metal, and measure approximately 11 inches long by 5 inches wide. Please note that this kit does not include the cover, ice level arm, or the wire harness. These parts can be ordered separately, or you can use the existing parts from the original ice maker. This Replacement Ice Maker is a genuine OEM part and is also known as an Ice Maker Assembly or a Refrigerator Ice Maker. Installation will require a quarter inch nut driver, and make sure that you disconnect your power and water supply before beginning this repair. Once the new part is in place, your fridge will begin making ice again within a few hours.

Fix Number

FIX12731166

Manufacturer Part Number

W11396033

This part includes one authentically sourced 3-pin rocker switch for a refrigerator. It is responsible for turning the light on inside the fridge when the door is open. It is commonly replaced because the light has stopped turning on with the door open. For this simple repair, start by disconnecting the power. Use a putty knife and a flathead screwdriver to pry the door switch out of the liner. Disengage the wire harness to release the damaged switch. Install the new door switch by first connecting it to the wire harness. Line the switch up on the liner and snap it into position. Power it back up and double-check that it is working.