Kenmore Refrigerator Light Bulb - 40W 8009 | Fix.com

Light Bulb - 40W

&SeePartX&
884734-1-S-Whirlpool-8009              -Light Bulb - 40W
https://fixcom.azureedge.net/Schematics/Maytag/1913.gif
Click for the BBB Business Review of this Appliances - Small - Supplies & Parts in Dartmouth NS
Part Description:
This replacement light bulb is sold individually.
This part works with the following brands:
Part number cross reference:
This part works with the following products:
Refrigerator, Range, Wall Oven, Dryer, Microwave Oven Combo, Microwave, Freezer, Washer, Washer Dryer Combo, Range Hood, Cooktop, Air Conditioner.

Installation Videos

Replacing your Kenmore Refrigerator Light Bulb - 40W
Watch this how to video with simple, step-by-step instructions for a successful DIY repair.
Replacing your Kenmore Refrigerator Light Bulb - 40W
Watch this how to video with simple, step-by-step instructions for a successful DIY repair.

Installation Instructions

Showing 1-10 of 14 Instructions
>
page 1 of 2
<

Customer broke light base

With power off, simply take small screwdriver and insert from interior of old socket to bend inward (each side) a small retaining tab that holds socket assembly in place. Once both tabs are bent inward, sockets pulls out easily; be careful not to lose spade terminals connected on rear. Reattach spade connectors (2) to new socket assembly, and firmly press them back into rear corner of oven which you will here a snap when side clips engage. Insert new bulb and lens cover.

Were these instructions helpful?

1 of 1 people found these instructions helpful
Parts Used: Oven Light , Light Bulb - 40W
Difficulty Level: Really Easy
Total Repair Time: Less than 15 mins
Tools: Pliers
Customer: Steven from Hickory, NC

No ice coming out of door

Removed front dispenser panel with screwdriver pryed it off. And discover micro switch had come out of holder control bracket. Order and replace bracket. Easy peasy. Old switch back in place. Panel back on. Done.

Were these instructions helpful?

1 of 2 people found these instructions helpful
Parts Used: Crisper Drawer with Humidity Control , Control Bracket , Light Bulb - 40W
Difficulty Level: Really Easy
Total Repair Time: 30 - 60 mins
Tools: Screw drivers
Customer: cono from malden, MA

Lightbulb in refrigerator went out

Removed plastic shield on top of refrigerator. Removed old bulb.. Replaced new bulb. Reinstalled plastic shield. Voila!

Were these instructions helpful?

2 of 5 people found these instructions helpful
Parts Used: Light Bulb - 40W
Difficulty Level: Very Easy
Total Repair Time: Less than 15 mins
Tools:
Customer: Helen from Quincy, MA

Lower element burned in two pieces

The first thing we did was remove the oven door in order to reach the connection, which is in the right back of the oven. It was easy to clip the connection in using a needle nose pliers. Then we gently pushed the element back into the insulation and stabilized the element by screwing the plate to the back of the oven. Then we simply put the door back on. Very easy.

Were these instructions helpful?

0 of 1 people found these instructions helpful
Parts Used: Lower Bake Element , Light Bulb - 40W
Difficulty Level: Really Easy
Total Repair Time: 15 - 30 mins
Tools: Pliers, Screw drivers
Customer: Sharon from Voss, TX

Broken glass on oven light fixture

Original light fixture difficult to remove. I could not see or feel tabs holding fixture to chassis. In anger I finally used hammer and screwdriver to forcibly remove fixture, destroying it in the process. Happily, the new fixture snapped into the hole as advertised.

Were these instructions helpful?

0 of 1 people found these instructions helpful
Parts Used: Light Socket , Light Bulb - 40W
Difficulty Level: A Bit Difficult
Total Repair Time: 15 - 30 mins
Tools: Pliers, Screw drivers
Customer: Pat from Auburn, WA

Light bulb bruned out

take out old bulb, twist in new bulb. make sure not to over twist it in.

Were these instructions helpful?

0 of 1 people found these instructions helpful
Parts Used: Light Bulb - 40W
Difficulty Level: Very Easy
Total Repair Time: Less than 15 mins
Tools:
Customer: Esther from Gunnison, CO

Description of installing was shot on info

first of all there were four screws to take out not just 2 then since there was 1 wire more on old that had to be completely remove & disregarded that wasn't in replacement info an the fact that picture digram was upside down made connecting coded wires complicated because old burner was faceing up once you take wires off old one & ellinate extra wire and not all wires were colored same had to try 4-time in changing wire slots that 4-time had to shut off breakers to electric an hope that the next time the wire config would be wright, if the had put all info about taking it apart & tuned diagram write side up there would not have been any problem changing ,should have had more instruction

Were these instructions helpful?

0 of 1 people found these instructions helpful
Parts Used: Light Bulb - 40W , Haliant Burner with Limiter - 6" - 1500W
Difficulty Level: A Bit Difficult
Total Repair Time: 1- 2 hours
Tools: Screw drivers, Socket set
Customer: karen from lily, KY

Touchpad controls weren't responding, couldn't change settings/temp

You have to unscrew the pivot plate from the upper middle of the cabinet first. Then slide back and remove the clear lightbulb cover. Use a thin flat screwdriver to pry off the entire bracket assembly from the roof of the fridge, being careful to unlatch the plug for the electrical wires. Use the screwdriver to pop off the plastic part covering the cable connection for the old touchpad, then peel off the old touchpad and unplug it. Plug in the new part, pressing it into place - it's self-adhering.

Were these instructions helpful?

0 of 1 people found these instructions helpful
Parts Used: KEYBOARD- , Light Bulb - 40W
Difficulty Level: Very Easy
Total Repair Time: Less than 15 mins
Tools: Screw drivers
Customer: Karen from Redondo Beach, CA

Oven would not heat up

We looked online found this site. Looked up the part number for our oven. We received it within 3 days. We read the first set of instructions on how to install. Was fixed within 30 minutes. This Company is AWESOME, very reliable, excellent service! The person who submitted the instructions did a great job. Saved us a bundle!

Were these instructions helpful?

0 of 1 people found these instructions helpful
Parts Used: Light Bulb - 40W , Round Style Oven Igniter
Difficulty Level: Very Easy
Total Repair Time: 15 - 30 mins
Tools: Screw drivers, Socket set
Customer: Mark from Salem, OR

Bake element quit working

Killed main power to house ! Removed old element screws & un-plugged old one then put new one in place and replaced screws till tight all done less then 5 min turn power back on and start cooking . Ps you will need a flash light also

Were these instructions helpful?

0 of 1 people found these instructions helpful
Parts Used: Light Bulb - 40W , Bake Element - 240V 2100W
Difficulty Level: Really Easy
Total Repair Time: Less than 15 mins
Tools: Screw drivers
Customer: julie from LARGO, FL
Showing 1-10 of 14 Instructions
>
page 1 of 2
<

Model Cross Reference List

This part works with the following models:

Fix Number: FIX884734
Manufacturer Part Number: 8009


Brand Model Number Description
Litton102000Microwave - Table Top
Litton102001Microwave - Table Top
Litton102002Microwave - Table Top
Kenmore103281610Range
Kenmore103285450Range
Kenmore103285451Range
Kenmore103291610Range
Kenmore103291610-SRange
Kenmore103291820Range
Kenmore103293060Range
Kenmore103294060Range
Kenmore103296010Range
Kenmore103296011Range
Kenmore103296015Range
Kenmore103298070Range
Kenmore10330181Wall Oven
Kenmore1033023200Wall Oven
Kenmore1033023210Wall Oven
Kenmore1033025200Wall Oven
Kenmore1033026520Wall Oven
Kenmore1033026521Wall Oven
Kenmore1033033400Wall Oven
Kenmore1033033410Wall Oven
Kenmore1033035000Wall Oven
Kenmore1033035400Wall Oven
Kenmore1033035500Wall Oven
Kenmore1033035600Wall Oven
Kenmore1033035800Wall Oven
Kenmore1033035900Wall Oven
Kenmore1033036500Wall Oven