OEM Hardwick Microwave Oven Combo Parts | Expert DIY Repair Help & Fast Shipping | Fix.com

Popular Hardwick Microwave Oven Combo Parts

$5.02
Light Bulb - 40W
Fix Number FIX2376034
Manufacturer Part Number 8206232A
This 40W light bulb has a small screw in base. It screws into the bottom panel of your microwave.
Fixes these symptoms
No Symptoms for this part
Installation Instructions
Mark from North East, PA says,

Bulb burnt out
Removed the screw holding the bulb cover replaced the bulb. Reinstalled the cover and screw. Remove dirty grease filter replaced with new grease filter....read more

$4.51
Light Bulb - 40W
Fix Number FIX884734
Manufacturer Part Number 8009
This replacement light bulb is sold individually.
Fixes these symptoms
No Symptoms for this part
Installation Instructions
Helen from Quincy, MA says,

lightbulb in refrigerator went out
Removed plastic shield on top of refrigerator. Removed old bulb.. Replaced new bulb. Reinstalled plastic shield. Voila!...read more

$4.78
Chrome Drip Bowl - 8 inch
Fix Number FIX11750107
Manufacturer Part Number WPW10196405
This Chrome Drip Bowl is an OEM approved replacement part sourced directly from the Whirlpool, and is intended for use with various models electric ranges and cooktops manufactured by Whirlpool, Amana, Magic Chef, Maytag, Roper, Caloric, Crosley, Admiral, Hardwick, Norge, Litton, Kenmore, KitchenAid, Hoover, Jenn-Air, Inglis, Estate, and Glenwood. For full compatibility, please see the "Model Cross Reference List" below. This Drip bowl fits under 8" burner elements, and has a diameter of approximately 10". While the replacement may be visually different from the original, it will fit your appliance. If your Drip Bowl has become discolored, corroded, or otherwise damaged, it needs to be replaced. Each Drip Bowl is sold individually, and may also be referred to as a Drip Pan. No tools are required for installation, simply line up the hole on the bowl with the terminal block and drop it into place.
Fixes these symptoms
Element will not heat


Installation Instructions
Henry from St Louis, MO says,

Replace old drip Bowls
Remove heating elements, remove old drip bowl, install new drip bowls replace heating elements....read more

$4.16
Drip Bowl - 6"
Fix Number FIX11750108
Manufacturer Part Number WPW10196406
This Drip Bowl is an OEM approved replacement part designed for use with various models electric ranges and cooktops manufactured by Whirlpool, Amana, Magic Chef, Maytag, Roper, Caloric, Crosley, Admiral, Hardwick, Norge, Litton, Kenmore, KitchenAid, Hoover, Jenn-Air, Inglis, Estate, and Glenwood. For full compatibility, please see the "Model Cross Reference List" below. This Drip bowl fits under 6" burner elements, and has a diameter of approximately 8". While the replacement may be visually different from the original, it will fit your appliance. If your Drip Bowl has become discolored, corroded, or otherwise damaged, it needs to be replaced. Each Drip Bowl is sold individually, and may also be referred to as a Drip Pan. No tools are required for installation, simply line up the hole on the bowl with the terminal block and drop it into place.
Fixes these symptoms
Element will not heat


Installation Instructions
Henry from St Louis, MO says,

Replace old drip Bowls
Remove heating elements, remove old drip bowl, install new drip bowls replace heating elements....read more

$7.19
Drip Bowl - 6"
Fix Number FIX2366565
Manufacturer Part Number W10196406RW
This part has been substituted by the manufacturer and now has a hole in the center. This Drip Bowl is an OEM approved replacement part designed for use with various models of electric ranges and cooktops manufactured by Whirlpool, Amana, Magic Chef, Maytag, Roper, Caloric, Crosley, Admiral, Hardwick, Norge, Litton, Kenmore, KitchenAid, Hoover, Jenn-Air, Inglis, Estate, and Glenwood. For full compatibility, please see the "Model Cross Reference List" below. This Drip bowl fits under 6" burner elements, and has a diameter of approximately 8". While the replacement may be visually different from the original, it will fit your appliance. If your Drip Bowl has become discolored, corroded, or otherwise damaged, it needs to be replaced. Each Drip Bowl is sold individually, and may also be referred to as a Drip Pan. No tools are required for installation, simply line up the hole on the bowl with the terminal block and drop it into place.
Fixes these symptoms
Element will not heat


Installation Instructions
chris from ABERDEEN, SD says,

Burner would not heat up and the cook top on light would not turn off.
First turn off breaker. Pull out stove and unplug. There was about 8 screws on the panel on the back side of the control panel. Remove panel. Remove knob on the bad control and there is 2 screws behin...read more

$35.21
Flat Style Oven Igniter Kit
Fix Number FIX1573892
Manufacturer Part Number 12400035
The flat style gas oven igniter included in this kit has a body length of 3-3/4 inches. This kit comes with all of the pieces you need to replace longer ceramic igniters, though this kit can also replace short igniters. This igniter has an amperage range of 3.3 - 3.6 and does NOT replace round style oven igniters.
Fixes these symptoms
Element will not heat
Gas igniter glows, but will not light
Gas smell

See more...
Installation Instructions
David from ENCINITAS, CA says,

Wall oven would take a very long time to ignite.
One of the 2 screws that holds the igniter to the burner assembly was stripped and difficult to get out. Other than that it was an easy fix....read more

$35.02
2 Piece Broiler Pan
Fix Number FIX971245
Manufacturer Part Number 4396923
The top of this part is now black.
Fixes these symptoms
No Symptoms for this part
$18.93
Terminal Block
Fix Number FIX11750972
Manufacturer Part Number WPW10245259
It provides a way of connecting individual electrical wires and offers protection of the device from electrical surges (voltages and/or currents).
Fixes these symptoms
Element will not heat
Little to no heat when baking
Will Not Start

See more...
$53.86
Bake Element (16" long x 16" wide)
Fix Number FIX11757472
Manufacturer Part Number WPY04000066
This bake element with push on wire terminals is located in ranges and ovens. The terminal depth is 3 inches, the total element length is 19 and the wire terminals are 16 inches wide. Detailed installation instructions are found in the manual provided by the manufacturer. If your element is not heating then replacing it can solve your problem.
Fixes these symptoms
Element will not heat
Little to no heat when baking
Oven not heating evenly

See more...
Installation Instructions
GLENN from CHINO HILLS, CA says,

Bake element broke in half.
Disconnect electric.
Remove 2 screws.
Pull out old unit.
Disconnect wire connect tabs.
Install new unit.
Connect wire tabs.
Replace 2 screws...read more

$6.34
Surface Burner Plug-In Block Kit
Fix Number FIX340571
Manufacturer Part Number 330031
This is a genuine OEM replacement part. This surface burner plug-in block kit is designed for use with surface elements of your ranges and cooktops. This kit helps connect the wire harness to the surface element. If your element is not heating, or if it only heats intermittently you may have an issue with your terminal block. This is a newer-style terminal block kit, it includes the plastic receptacle block, two metal brackets, two pre-crimped hi-temp wire leads with terminals, two ceramic nuts, two screws, and heat shrinking insulators. Before beginning this repair make sure you have unplugged your appliance.
Fixes these symptoms
Element will not heat


Installation Instructions
Doris from Skoke, IL says,

Elements heat sporatically
I followed the steps in the instructions which were very easy, once the electric power was turned off to the range. I replaced 2 burner plug in blocks in less than 30 minutes. I am embarrassed to sa...read more

Popular Hardwick Microwave Oven Combo Models