Roper Refrigerator Parts

3 Reviews

Fix Number: FIX11739091
Manufacturer Part Number: WP2187172

This door bin is sold individually. Its dimensions are 18 inches wide, 4.5 inches high, by 7 inches deep.

Fixes these symptoms

Door won’t open or close
Ice maker not making ice
Leaking
See more...

Installation Instructions

Renee from FITCHBURG, MA

my door bin cracked and broke

lifted and removed old bin
replaced with new bin Read more...

Refrigerator Capacitor

$46.07

2 Reviews

Fix Number: FIX11757023
Manufacturer Part Number: WPW10662129

The capacitor, also known as a run capacitor, is a component in your fridge that allows the compressor to cycle on and off to maintain a constant temperature. If your fridge and freezer are too warm it may be necessary to replace the capacitor. Other symptoms include an unusually noisy and overheated compressor. You can check the capacitor for continuity using a multimeter. This is a genuine OEM replacement part made of black plastic that measures 1 inch by 1.5 inches. When replacing this part, be sure to check the electrical contacts on the old capacitor. If they are corroded or burnt, you will need to replace the overload relay assembly as well. Be sure to disconnect the power supply to your refrigerator before beginning this repair.

Fixes these symptoms

Clicking sound
Freezer not defrosting
Freezer section too warm
See more...

Installation Instructions

Lisa from Yulee, FL

Both comparments very warm but fan working and lights on

Bought Capacitor, but I had to purchase Combo Start Up Kit that Cap goes into. The site said that 78% of the time my problem of both compartments being warm were resolved/repair by replacing Capacitor, but when the item was replaced it did not and my son looked further and found that it would then be the Combination Start Up Kit (Part# PS11740412), which starts the compressor. Thanks to this site the video used to install both parts. I was able to use the old Capacitor and I am returning the new one first purchased. Read more...

Refrigerator Crisper Drawer With Handle

$60.49

4 Reviews

Fix Number: FIX11739122
Manufacturer Part Number: WP2188664

This clear convertible meat drawer is for the lower part of the refrigerator. It has an air duct that allows cold air to flow into the drawer from the freezer. It can be used to store meats and vegetables to help preserve them for longer. If the food that is kept inside it is going bad quicker than usual, it could be in need of a replacement. If the drawer is not moving in and out smoothly, check to make sure the tracks that it slides on are in good condition. If they are, the drawer itself may be damaged. Usually damage is visible, so do a quick inspection for cracks or warping. This part is sold separately and measures roughly 16 7/16 inches wide, 14 5/16 inches deep, 1 5/8 inches high, and like all the parts we sell, is OEM approved. Keep in mind that your refrigerator has multiple options for meat and vegetables drawers, so be sure to check your user manual to ensure you are ordering the one you need.

Fixes these symptoms

Door won’t open or close
Leaking
See more...

Installation Instructions

Peter from Fernandina Beach, FL

cracked crisper

installing a crisper container in the refridgerator Read more...

Refrigerator Ice Bucket

$98.81

Fix Number: FIX11757044
Manufacturer Part Number: WPW10670845

If you need a new bucket for your ice maker, this is a genuine OEM replacement part. Over time and with regular use, the ice bucket can become cracked and not function properly. If this happens the bucket should be replaced so you can continue to use the ice maker as intended. This includes just the bucket, when replacing this part, you will need to remove the other components from the old ice bucket and reinstall them onto the new piece.

Fixes these symptoms

Ice maker not making ice
Ice maker won’t dispense ice
Leaking
See more...

Installation Instructions

Derek from kansas city, MO

The ice bucket broke due to a large piece of ice being pushed down by the cork screw and cracking the bottom

bought the part, dissassembled the damaged piece and reassembled using the repalcement part. Read more...

Replacement Ice Maker

$123.87

6 Reviews

Fix Number: FIX358591
Manufacturer Part Number: 4317943

The ice maker works by filling with water from the inlet valve, freezing it into cubes, and then dispensing the cubes into the storage bucket. It will then refill with water and repeat this process until the ice storage bucket is full. If yours is not making ice or it is leaking, it may be time to replace the ice maker. Depending on usage and water quality, these should be replaced every three to ten years. Please note that this kit does not come with a new shut off arm (also known as a bail arm). You will need to reuse the arm from your old ice maker, or you can purchase a new one separately. This genuine OEM parts kit includes the replacement ice maker, wire harnesses (flat and round plug versions), and the mounting hardware. The wire harness from your old ice maker can also be reused if you choose. This model is approximately 11x5 inches in size, made of plastic and metal, and is black and silver in color. This model does not work with refrigerators that have the ice auger on the door, it is meant to sit in the upper left hand of the freezer. Please ensure that you disconnect the power and water supply before beginning this repair. ***NOTE: Ice maker does NOT come with the bail or shut off arm. You must order them separately if required. It does come complete with flat and round plug wiring harness, the mounting hardware, and the instructions. The harness can be reused. The ice maker will not fit refrigerators that have the ice auger mounted on the door.

Fixes these symptoms

Ice maker dispenses too little ice
Ice maker dispenses too much ice
Ice maker not making ice
See more...

Installation Instructions

ron from aliquippa, PA

ice maker not working properly

replace ice maker Read more...

Water Inlet Valve

$80.13

Fix Number: FIX3497634
Manufacturer Part Number: W10408179

If the ice maker or water dispenser on your fridge are not working, or there is water leaking, it may be an issue with your water inlet valve. This part is found at the back of your refrigerator and supplies the water to both your ice maker and water dispenser. The materials can be worn out over time with regular use and should be replaced. Another area on the valve to inspect is the solenoids, which can be done with multimeter to check for continuity. This is a genuine OEM part that measures approximately 6.5 inches long by 3 inches wide and is made of plastic and metal. To replace this part, you will need access to the back of your fridge. Please ensure that you disconnect the power and water supply before beginning this repair.

Fixes these symptoms

Ice maker dispenses too little ice
Ice maker not making ice
Ice maker won’t dispense ice
See more...

Installation Instructions

John from Bennettsville, SC

none

watch video Read more...

EveryDrop Water Filter

$80.70

Fix Number: FIX11722132
Manufacturer Part Number: EDR5RXD1

This refrigerator filter helps reduce contaminants in your water and ice using advanced Triple Filtration Technology. It’s designed to improve taste and quality for drinking and cooking. Replace every six months to keep your water clean and your filter working effectively.

Fixes these symptoms

Ice maker dispenses too little ice
Ice maker not making ice
Ice maker won’t dispense ice
See more...

Installation Instructions

Jack from Chappaqua, NY

Dirty water filter

Unscrewed old filter, removed cap, replaced with new filter. Read more...

Refrigerator Lower Door Closing Cam

$9.79

Fix Number: FIX11739042
Manufacturer Part Number: WP2182179

The lower door closing cam raises the door to keep it from touching the refrigerator liner when the door is closed. It fits both the left and right side of the refrigerator door. The most common reasons for replacing this part are the fridge door slips down when opened, the door does not open smoothly, or does not close by itself. This original part is made of durable black plastic, is approximately 1.1 inches by 1.5 inches, and is sold individually. To effectively install this part, you will need a 5/16 nut driver and a small flat blade screwdriver. Before you begin, disconnect the power and the water supply. We suggest lubricating this part before installing. To make the repair, remove the top hinge cover, then the top hinge support. Lift the door from the bottom support and remove the old door cams. Replace the cams and put the door back on the lower hinge support. Replace the top hinge support and that completes the repair.

Fixes these symptoms

Clicking sound
Door Sweating
Door won’t open or close
See more...

Installation Instructions

Curtis from Highland, UT

The door would not stay closed, the closing cams were completely worn out.

This is a very simple repair, by far the hardest part was emptying all of the condiments out of the door. After that was done I removed the top hinge cover and then the hinge. I lifted the door off of the refrigerator and set it on a card table so that it was off the ground. I took the worn cams off of the door and the refrigerator cabinet (one screw for each of them). I screwed the new cams into position and lubricated them with petroleum jelly. Then I put the door back in position and reattached the top hinge. It works perfectly again. Read more...

Refrigerator Door Cam

$9.79