Snapper Parts

Snapper Appliance Parts

Popular Snapper Parts

Fix Number
FIX9285148
Manufacturer Part Number
530095646
This fuel filter is for lawn and garden equipment engines. Fuel filter cleans the fuel before it reaches the carburetor. Work in a well-ventilated area when installing this part. Drain the fuel tank and disconnect the spark plug wire before beginning the repair.
Fixes these symptoms
  • Engine stops after a few seconds or minutes
  • Will Not Start
  • See more...
Fuel Line
$9.93
Special Order
★★★★★
★★★★★
1 Review
Fix Number
FIX9472280
Manufacturer Part Number
530069247
This chainsaw fuel line kit carries fuel from the tank into the carburetor and from the primer bulb to the fuel system. This part is mostly used on gas trimmers and blowers. The fuel lines are made from clear, flexible, and rubber material. In time, this part can begin to deteriorate, which can result in leaks. To prevent this, make sure to replace the fuel line. As a safety precaution, remember to wear work gloves to protect your hands during repair.
Fixes these symptoms
  • Engine stops after a few seconds or minutes
  • Will Not Start
  • See more...

Installation Instructions

Larry from Sanford, NC
fuel line is very tight going on
Using forceps, hold tight grip on fuel line about only 1/8 of an inch back of end and lube lightly. Push slowly and work onto nipple. Read more...
Tank Purge Line
$8.98
Special Order
Fix Number
FIX9472264
Manufacturer Part Number
530069216
This is a tank purge line, also known as a fuel line kit, and it is used with various lawn equipment. The line connects fuel from the tank into the carburetor, and from the primer bulb back into the fuel system. The extra fuel is forced through the line into the fuel tank. This tube is transparent, and has a diameter of 3/16 inches. Before making this repair, we recommend draining the fuel from your machine, and removing the spark plug.
Fixes these symptoms
  • Engine stops after a few seconds or minutes
  • Will Not Start
  • See more...
Nut, Flange Lock, 5/16-18, Grf
$5.95
In Stock
Fix Number
FIX9092936
Manufacturer Part Number
712-04063
This nut is fit for lawn and garden equipment and is used to resist loosening when properly threaded onto a bolt. The nut is sold individually. The diameter of the nut is 5/16 inches and the thread size is 18. Refer to the manual provided by the manufacturer for repair instructions.

Installation Instructions

Ronald from SPEARFISH, SD
Replace sheave plate and side skid shoes on snowblower.
Remove eight bolts and two skid shoes and bottom sheave plate. Replace in reverse order.
Most important, get the correct OEM parts from FIX.com. Refer to product parts list in model instruction manual.
Do that first and you too can see how easy this repair is and save big bucks charged by retail repair shop!
Read more...
Spark Plug
$6.89
In Stock
Fix Number
FIX8996057
Manufacturer Part Number
503235111
By replacing your spark plug as part of your regular maintenance, this ensures a better performing engine, cleaner exhaust, faster starting, and a smooth-running engine. This spark plug is sourced directly from the manufacturer and is sold as a single unit. If upon inspection you notice the spark plug is dirty or otherwise damaged, it should be replaced right away. Removing the spark plug may require a wrench and should only take a few minutes to complete.
Bulb-Purge "snap-in"
$9.93
Special Order
Fix Number
FIX9471212
Manufacturer Part Number
530047721
If your engine is having trouble starting, you may be in need a new purge bulb. When the engine has been sitting for a while, unused, the fuel will drain and eventually dissolve out of the carburetor. The next time you go to use your equipment, the engine will not start until the carburetor has fuel in it. The purge bulb, also commonly referred to as a primer bulb, manually pumps fuel back into the carburetor, while purging air out. If the purge bulb is malfunctioning, you will need to pull the starter rope numerous times until the carburetor diaphragm can pump the right amount of fuel back into carburetor for the engine to start. This purge bulb is prone to hardening and cracking over time because it is in continuous contact with fuel and will need to be replaced. This part is sourced directly from the manufacturer and sold individually.
Belt, Drive V3L
$19.25
In Stock
Fix Number
FIX8891963
Manufacturer Part Number
1733324SM
Belt, Auger V 3L
$22.94
In Stock
Fix Number
FIX9042546
Manufacturer Part Number
585416MA
Mulching Blade
$29.79
In Stock
Fix Number
FIX9169783
Manufacturer Part Number
942-0741A
This is a mulching blade for your lawn mower. It is located underneath the lawn mower deck, and cuts the grass by rotating. This blade has a curved style shell, and includes extra cutting surfaces along the edges of the blade. If installed correctly this part will keep the grass clipping under the deck longer, and re-cut them. The blade is 21 inches long, and sold individually.
Fixes these symptoms
Primer Bulb Kit
$12.43
Special Order
Fix Number
FIX9472698
Manufacturer Part Number
530071835
This is a single OEM purge bulb, also sometimes referred to as a primer bulb. It is usually located close to the starter rope. By pressing down on the purge bulb, this forces fuel into the fuel line from the fuel tank and into the carburetor to help get the engine started. Due to its constant contact with fuel, the bulb is prone to damage over time and will need to be replaced.
Fixes these symptoms

Installation Instructions

Larry from Sanford, NC
fuel line is very tight going on
Using forceps, hold tight grip on fuel line about only 1/8 of an inch back of end and lube lightly. Push slowly and work onto nipple. Read more...

Snapper Appliance Types