Official Amana Washer Hardware

Agitator Bolt

$7.01

Fix Number: FIX11741866
Manufacturer Part Number: WP358237

This bolt is a genuine OEM replacement part, used to secure the agitator in your washing machine. Overtime the bolt can become worn out due to the vibrations of the washer, and will need to be replaced. The size of the screw head is 7/16 inch, so you will need the appropriately sized socket to complete this repair. The new bolt comes with a rubber gasket and a threaded sealant.

Fixes these symptoms

Leaking
Marks left on clothes
Spinning Issues
See more...

Watch the install video

Washer

$7.66

★★★★★

1 Review

Fix Number: FIX11742027
Manufacturer Part Number: WP3949550

This part goes on the agitator retaining bolt.

Fixes these symptoms

Leaking
Will not agitate
See more...

Screw, 8-16 x 1.000

$7.93

Fix Number: FIX11746167
Manufacturer Part Number: WP8533953

Sold individually.

Boot Seal Retaining Ring

$16.10

Fix Number: FIX12584490
Manufacturer Part Number: W11266654

Fixes these symptoms

Leaking
See more...

Screw, 8/18 x 3/8

$5.61

Fix Number: FIX11746840
Manufacturer Part Number: WP90767

This is a multi-use screw and can be used on a variety of appliances. The measurements of the screw are: 8/18 x 3/8. *Please note: the screw is sold individually. Refer to the manual provided by the manufacturer for further repair guidance.

Watch the install video

Suspension Spring Retainer

$7.36

Fix Number: FIX11749057
Manufacturer Part Number: WPW10145155

This is a replacement suspension spring retainer for your washer. The retainer holds the suspension spring in place while the washer is operating. If you notice movement, or an unusual noise or shaking of your washer when it is in use, it could mean that the suspension spring has been disconnected because of a broken or missing spring retainer. You will find the suspension spring retainer at the bottom of the tub assembly. To replace the retainer, use a pair of pliers to disconnect the suspension spring from the chassis mount to relieve the tension. Then, remove the spring from the retaining clip, and remove the retaining clip from the bottom of the washer. Attach the new retaining clip to the bottom of the washer, reattach the spring, and stretch it slightly so it can connect to the chassis. This part is sold individually.

Fixes these symptoms