Amana Washer Switches

★★★★★

★★★★★

6 Reviews

Fix Number

FIX11745957

Manufacturer Part Number

WP8318084

On the lid on your washing machine there is a pin that engages with the lid switch. This works by telling the machine that the lid is closed which then allows for the washer to start. If your washer is not starting, or does not advance through the different cycles, there may be a problem with your lid switch. This part can wear out or become damaged over time and will need to be replaced so your machine can operate. Replacing this genuine OEM part is an easy job that requires the use of a Philips screwdriver along with a 5/16-inch nut driver. You will need to disconnect the power to your washer before beginning this repair and pull the machine away from the wall so you can easily access the back panel. Since the lid switch is found underneath the control panel, you will need to unscrew and lift the panel back to gain access. In order to remove the old switch, you first disconnect the wire harness, and remove the screw holding the grounding wire in place. The lid of the washer needs to be lifted, as the pin will be engaged with the switch if the lid is in the closed position. With the lid still open, the new switch can be put in place, install the screw for the grounding wire, and reattached the wire harness. The control panel can then be lowered back down, ensuring the locking tabs are engaged.

Fix Number

FIX11754877

Manufacturer Part Number

WPW10448876

This part is located behind the control panel. It helps determine the level of water in the washer. As the water fills the hose, while tub is filling, it will push the air against a diaphragm inside the switch. More water that enters the tub, more pressure is applied against the switch.

★★★★★

★★★★★

1 Review

Fix Number

FIX1964648

Manufacturer Part Number

W10169313

This part replaces older two terminal switches.

★★★★★

★★★★★

1 Review

Fix Number

FIX11739302

Manufacturer Part Number

WP22001682

This black lid switch assembly comes complete with a bracket, two switches, and a fuse. An open fuse might indicate that the lid switch is bad. The point of the lid switch is for the tub to stop spinning when the washer lid is opened. It is a safety precaution just in case someone decides to stick their hand inside the washer while the tub is spinning.

★★★★★

★★★★★

1 Review

Fix Number

FIX11755855

Manufacturer Part Number

WPW10514214

This water level switch senses the level of water in the inner tub.

★★★★★

★★★★★

1 Review

Fix Number

FIX3408119

Manufacturer Part Number

W10337781

This water level switch senses the level of water in the inner tub.

Fix Number

FIX3408149

Manufacturer Part Number

W10339251

This part is located behind the control panel. It helps determine the level of water in the washer. As the water fills the hose, while tub is filling, it will push the air against a diaphragm inside the switch. More water that enters the tub, more pressure is applied against the switch.

Fix Number

FIX11749784

Manufacturer Part Number

WPW10184148

This part regulates the temperature of the water in the tub.

Fix Number

FIX11738787

Manufacturer Part Number

WP207166

This is used to start your washer once the desired water level is reached.

Fix Number

FIX2002890

Manufacturer Part Number

12001187

This kit includes the bracket, actuator, switch, screws and wire harness.