Maytag Wall Oven Parts

Maytag Appliance Parts

Popular Maytag Wall Oven Parts

Long Oven Sensor
$34.72
In Stock
★★★★★
★★★★★
1 Review
Fix Number
FIX1570174
Manufacturer Part Number
12001656
This is a factory-certified oven sensor kit with two harness adapters. Its purpose is to sense the temperature inside the oven. Replacing this part can fix an oven that is not reaching the proper temperature (too hot or not hot enough), not heating evenly, or an oven that will not start. To access this part, you will need access to the back of the range. Use a Phillips screwdriver to remove the screws on the access panel. Once the access panel is removed, you will notice a hole on the right side of the oven where the temperature sensor comes out of the oven. You will need to unplug the wire harness, and then open the oven door, locate it in the upper left corner, and remove the screws holding the temperature sensor in place. Pull the sensor out of the back of the oven, and replace it with your new part.
Fixes these symptoms
  • Door won’t open after self cleaning cycle
  • Element will not heat
  • Little to no heat when baking
  • See more...

Installation Instructions

Michael from Pearl River, NY
Oven did not heat up
Removed the oven door, removed existing screws. Pulled wire carefully out of opening, unclip connection. Reattached connection screwed back new sensor attached oven door finished. Read more...
Inner Door Glass
$112.15
In Stock
★★★★★
★★★★★
3 Reviews
Fix Number
FIX11742543
Manufacturer Part Number
WP4449259
The glass panel on the door of your range allows you to see your food as it is being cooked in the oven. If it has become damaged, broken, or so grimy that it is beyond cleaning, it should be replaced. This is a genuine OEM heat resistant panel that measures approximately 10 inches by 20 inches. It is the innermost glass panel on the door and is sold individually. When replacing this panel, please be sure to wear proper protection such as gloves in case any glass breaks. Always be sure to disconnect the power supply to your range and ensure that it is cool to the touch before starting the repair.

Installation Instructions

Andrea from Folsom, CA
Broken glass
I googled it, perfect! Read more...
Thermal Fuse
$32.51
In Stock
Fix Number
FIX11756138
Manufacturer Part Number
WPW10545255
This thermal fuse is a manufacturer-approved replacement part for your oven. It is common for the oven to lose power after completing a self-cleaning cycle, and the thermal fuse is often at fault. Replacing the blown fuse is a fairly easy repair, and involved removing the top of the oven to swap out the fuse. Make sure to turn off the power source to the oven before beginning this repair.
Fixes these symptoms
  • Door won’t open after self cleaning cycle
  • Touchpad does not respond
  • Will Not Start
  • See more...
Fix Number
FIX1573892
Manufacturer Part Number
12400035
This flat style oven igniter kit is a genuine OEM replacement part for your gas range. When the igniter glows white hot, the heat opens the gas valve and ignites the fuel heating the burner assembly. If your igniter is only glowing orange or red, or not glowing at all, it will need to be replaced. This kit includes the igniter, ceramic wire nuts, an insulation pad, a metal bracket, and a variety of plug ends. This kit can be used for both short or long igniters, and the bake or broil element. However, it is not compatible with ranges that require round style igniters. The igniter has an amperage between 3.3 and 3.6. The element is very fragile and should be handled with care. Before beginning your repair be sure to disconnect both the power and gas supply to your range.
Fixes these symptoms
  • Element will not heat
  • Gas igniter glows, but will not light
  • Gas smell
  • See more...

Installation Instructions

David from ENCINITAS, CA
Wall oven would take a very long time to ignite.
One of the 2 screws that holds the igniter to the burner assembly was stripped and difficult to get out. Other than that it was an easy fix. Read more...
Temperature Sensor
$89.89
In Stock
Fix Number
FIX11748765
Manufacturer Part Number
WPW10131825
This temperature sensor detects the temperature within the oven cavity.
Fixes these symptoms
  • Element will not heat
  • Little to no heat when baking
  • Oven is too hot
  • See more...

Installation Instructions

Alison from Beaverton, OR
The range doesn't maintain constant heat and doesn't know the accurate temperature
Followed the excellent instructions, but it didn't work :(I think the control panel is bad. Read more...
Terminal Block
$34.05
In Stock
Fix Number
FIX11750972
Manufacturer Part Number
WPW10245259
It provides a way of connecting individual electrical wires and offers protection of the device from electrical surges (voltages and/or currents).
Fixes these symptoms
  • Element will not heat
  • Little to no heat when baking
  • Touchpad does not respond
  • See more...
Door Hinge
$98.18
In Stock
★★★★★
★★★★★
2 Reviews
Fix Number
FIX11744215
Manufacturer Part Number
WP74008014
If your oven door is not opening or closing easily, there may be an issue with the door hinge. The hinge uses spring tension to allow the door to stay open at an angle instead of dropping open. This genuine OEM hinge can be used on either the left or righthand side of the door, and measures approximately 20.5 inches long. This part is sold individually, however we recommend replacing both hinges at the same time, as they can wear out a similar rate.
Fixes these symptoms

Installation Instructions

Carolyn J. from Oswego, KS
Oven door Hinge was broke...Door would just fall open
Watched the video on the repair you supplied...gave us confidence to make the repair. As easy as the video shows. We went ahead and bought 2 hinges and replaced both sides, since we had it apart...We, however, took the opportunity to take the door completely apart and clean it very good. Went back together easy. The new parts fit perfectly and my oven looks and works like it is brand new..New light bulb was a snap too. So glad I found this company....fast shipping too. Will always look here first in the future. Read more...
Bake Element
$122.23
In Stock
★★★★★
★★★★★
1 Review
Fix Number
FIX11750370
Manufacturer Part Number
WPW10207398
This bake element is found on the bottom of the oven.
Fixes these symptoms
  • Element will not heat
  • Little to no heat when baking
  • Oven not heating evenly
  • See more...
Range Bake Element
$103.23
In Stock
★★★★★
★★★★★
2 Reviews
Fix Number
FIX11757472
Manufacturer Part Number
WPY04000066
This bake element with push on wire terminals is located in ranges and ovens. The terminal depth is 3 inches, the total element length is 19 and the wire terminals are 16 inches wide. Detailed installation instructions are found in the manual provided by the manufacturer. If your element is not heating then replacing it can solve your problem.
Fixes these symptoms
  • Element will not heat
  • Little to no heat when baking
  • Oven is too hot
  • See more...

Installation Instructions

GLENN from CHINO HILLS, CA
Bake element broke in half.
Disconnect electric.
Remove 2 screws.
Pull out old unit.
Disconnect wire connect tabs.
Install new unit.
Connect wire tabs.
Replace 2 screws
Read more...
Bi-Pin Halogen Bulb
$25.74
In Stock
Fix Number
FIX11744355
Manufacturer Part Number
WP74009925
This part is a replacement halogen lamp for your oven. The bulb is 25 watts and 120 volts. If your light bulb is burned out, this is the part that replaces it. Be sure to turn off power to your range hood before you begin this repair. This bulb is sold individually and is a genuine OEM part sourced directly from the manufacturer.

Installation Instructions

Jo Ann from Hillsborough, NC
Replace bulb in upper oven
This Jenn-Air stove is dual fuel (gas burners and electric ovens). The quartz bulb in the upper oven burned out. The bulb socket is inside a small compartment (1"x2") which is recessed into the top wall of oven. I was not able to plug the replacement bulb into the socket because of the small size of the socket compartment, the size of the bulb, and the fact that I could not align the bulb pins with the socket holes. I then noticed that the socket compartment was held in place with a single Phillips head screw. Once I removed this screw the socket compartment dropped down and I could plug the bulb in. I then replaced the compartment and re-inserted the screw. Read more...

Maytag Wall Oven Appliance Types

Related Maytag Wall Oven Parts

Popular Maytag Wall Oven Models