Maytag Wall Oven Sensors

★★★★★

★★★★★

1 Review

Fix Number

FIX1570174

Manufacturer Part Number

12001656

This is a factory-certified oven sensor kit with two harness adapters. Its purpose is to sense the temperature inside the oven. Replacing this part can fix an oven that is not reaching the proper temperature (too hot or not hot enough), not heating evenly, or an oven that will not start. To access this part, you will need access to the back of the range. Use a Phillips screwdriver to remove the screws on the access panel. Once the access panel is removed, you will notice a hole on the right side of the oven where the temperature sensor comes out of the oven. You will need to unplug the wire harness, and then open the oven door, locate it in the upper left corner, and remove the screws holding the temperature sensor in place. Pull the sensor out of the back of the oven, and replace it with your new part.

Fix Number

FIX11748765

Manufacturer Part Number

WPW10131825

This temperature sensor detects the temperature within the oven cavity.

★★★★★

★★★★★

1 Review

Fix Number

FIX2003225

Manufacturer Part Number

12001655

This temperature sensor detects the temperature within the oven cavity.

Fix Number

FIX11747165

Manufacturer Part Number

WP9755542

Also known as a meat probe.

Fix Number

FIX11744233

Manufacturer Part Number

WP74008369

This sensor detects the temperature within the oven cavity.

Fix Number

FIX11731446

Manufacturer Part Number

W10859573

Fix Number

FIX11757456

Manufacturer Part Number

WPY0314907

This is a genuine OEM replacement part. This temperature sensor is commonly used in ranges and wall ovens. This sensor determines what the internal cooking temperature of your appliance it. You may be getting error codes that indicate a problem, or you might notice the main indicator is that temperature in your oven will not match the reading. You can confirm there is a problem with your sensor by testing it with a multimeter. Some other symptoms include will not start, no heat, not enough heat, or too much heat. This replacement sensor is slight more than three inches in length, and it come with the wire connector. Some tools you may require for this installation are a 1/4-inch nut driver, needle nose pliers, and wire strippers/crimpers. Before starting this repair work make sure your appliance is unplugged.

Fix Number

FIX11740999

Manufacturer Part Number

WP31968201

This is a genuine OEM replacement part. Temperature sensors work to determine the internal cooking temperature of your wall oven or range. When you are getting a F3 error code on your range or wall oven that may indicate there is a problem with your temperature sensor. The main symptom of a faulty temperature sense is that the temperature in your oven will does match the reading on the control panel, you can confirm this issue by testing the sensor with a multimeter. Other signs you may have an issue with this part are having little to no heat when baking, your oven is getting too hot, your oven is not heating evenly, or your oven will not heat at all. To successfully install this replacement part you made need some basic hand tools such as a screwdriver, a 1/4-inch nut driver, needle nose pliers, and wire strippers/crimpers. Before starting nay repair job make sure you have unplugged your appliance.

Fix Number

FIX11743863

Manufacturer Part Number

WP71001870

This temperature probe consists of two ends joined together by an insulated wire. The small end is almost four inches long, whereas the longer end is almost seven inches long. The small end, the jack, plugs into the range, while the longer end, the probe, is inserted into the meat. This brown and metallic temperature probe is intended for use with some ranges and some older convection microwave ovens.

Fix Number

FIX7783890

Manufacturer Part Number

W10587533