Westinghouse Refrigerator Parts

Westinghouse Appliance Parts
Shop By Appliance Type Shop By Part Type

Popular Westinghouse Refrigerator Parts

$41.43
In Stock
Door Shelf Retainer Bar
★★★★★
★★★★★
1 Review
Fix Number FIX734935
Manufacturer Part Number 240534901
This is a genuine door shelf retaining bar for a refrigerator. It attaches to the inside of the door on the refrigerator and helps to secure items placed on the shelf. It is made of white plastic and can be easily installed without the use of tools. Start by making sure the projection on the inner door panel fits into the recessed area at the top of the shelf retainer bar. Once they are lined up, press it into place until you hear a snap. This part measures approximately 25-inches wide, 3-inches high, and 5-inches deep. If it breaks, cracks or warps over time, it will need to be replaced. This part is sold as an individual part. We recommend taking this opportunity to inspect the other shelf retaining bars for damage in case they also need to be replaced at the same time.
Fixes these symptoms
Installation Instructions
Kathleen from Parsippany, NJ
Needed to replace a broken bottom door shelf retainer bar on our older fridge.
I took the shelf retainer bar out of the shipping box, looked at the middle shelf to see how the bar sits on the brackets, and put it on. Took about 2 minutes. No tools needed. Done! Easy peasy! Read more...
$19.73
In Stock
Light Bulb
Fix Number FIX12751166
Manufacturer Part Number 316538904
Clear, 120 Volt, 40 Watt.
Installation Instructions
Chris from Lillington, NC
Broken bake element & light bulb
Turned of the power at the fuse box as the oven was hard wired to the electrical source and then removed the old element via the screws at the back of the oven. Disconnected the wires from the element and then reconnected those to the new element. Screwed the element base to the back wall of the oven and then replaced the light bulb. Read more...
$51.09
In Stock
Door Shelf Retainer Bar
★★★★★
★★★★★
3 Reviews
Fix Number FIX734936
Manufacturer Part Number 240534701
This middle shelf retainer bar attaches to the inside of the refrigerator door and helps to contain items on the shelf inside your appliance, like condiments and small containers. Its approximate size is 26 inches long, 3.5 inches tall, and made of white durable plastic. This part can start to wear or break over time, in which case it should be replaced. This is a beginner repair, that will not take any time at all. Start by removing the old part by pulling the tabs to release it. To install your new shelf, line it up with the shelf indents over the tabs, and gently press it down to lock in place. This is an OEM replacement part that is sold individually.
Fixes these symptoms
Installation Instructions
Gerard from Bayville, NY
door shelf retainer bar cracked in half
lifted each side of retainer bar off, slid new bar over moulded nubs on door, 123 done Read more...
$11.88
In Stock
Crisper Cover Support - Front
Fix Number FIX2358880
Manufacturer Part Number 241993101
If opening and closing your refrigerator is difficult, it could be due to a damaged or warped crisper cover front support. This part keeps the crisper shelf in place and mounts to the inside cabinet wall. Sold individually, this part is white in color, measures approximately 1 inch in diameter, and can be used for the front and rear support. The installation of this part is considered easy and should only take a few minutes. You will need a small flat blade screwdriver, putty knife, and soft hammer. Take the crisper and shelf out of the refrigerator first. To remove the old part, start by pushing the locking pin into the interior of the cabinet using the screwdriver, pull the support out with the putty knife. If taking out the pin is difficult, use a flat blade screwdriver to push it down and out of sight, this will not harm your refrigerator. Remove the pin and attach the new support, using a soft hammer to lock the new pin in place.
Fixes these symptoms
Installation Instructions
Michelle from Cypress, TX
Crisper cover support broke
I watched the video you had on your website---really easy-you guys ROCK! Read more...
$153.41
In Stock
Refrigerator Ice Maker Assembly
★★★★★
★★★★★
5 Reviews
Fix Number FIX12364147
Manufacturer Part Number 241798231
This is a genuine OEM ice maker assembly for your refrigerator. The ice maker makes eight cubes at a time, by filling the mold with water from the inlet valve, freezing the water until the cubes are formed, and then ejecting them into the storage bucket. This process will repeat until the ice bucket is full. If your device is not making ice cubes, the ice maker assembly may need to be replaced. Please ensure that you disconnect the power and water supply to your fridge before beginning this repair. This kit includes the fill cup, a four-pin wire harness adapter, and tube.
Fixes these symptoms
  • Clicking sound
  • Ice maker not making ice
  • Ice maker won’t dispense ice
  • See more...
Installation Instructions
Benedict from Simsbury, CT
Ice maker stopped making ice
Loosened 2 screws on left side freezer wall. Disconnected wire harness. Took out ice maker. Made sure screws extended far enough out to fit the new ice maker over them. Connected the wire harness. Put ice maker onto the 2 screws. Tightened the screws. Within a few hours we had ice. NOTE: use a mirror or you will fish blindly trying to find and tighten the screws. With the mirror, it was easy. Read more...
$50.33
In Stock
Drawer Support Rail - Right Side
★★★★★
★★★★★
1 Review
Fix Number FIX430917
Manufacturer Part Number 240530701
The drawer track support provides support for the right side of the sliding drawer to help it move open and closed easily. This part is sold individually, so if you also require the left side rail it will need to be ordered separately. It measures roughly 16 inches long by 1 inch high. If it is damaged it might make it difficult to open and close the fresh food drawer. Check the support rails in case something is blocking it. It is important to replace a damaged rail to prevent it from damaging the drawer itself. The only tool required for this repair is a Philips screwdriver. Remove the entire upper shelf from the inside of the fridge. Place the assembly on a flat work surface. Remove the screws on the back holding the back rail in place. Next, disengage the tabs holding the old right side rail in place. When installing the new one, line up the slotted opening on the rail to the tabs on the drawer and push it in until it snaps into place. Reinstall the back rail with screws. Check the operation of the drawer and place it back into the refrigerator.
Fixes these symptoms
Installation Instructions
Christine from Torrington, CT
Shattered glass shelf, broken shelf on door and broken track for deli drawer
Just put the parts where they belong Read more...
$116.89
In Stock
Refrigerator Crisper Pan
★★★★★
★★★★★
1 Review
Fix Number FIX429854
Manufacturer Part Number 240337103
This authentic replacement crisper pan, also known as a vegetable drawer, inserts into the refrigerator crisper area. It is used to hold produce and maintain an ideal temperature to help preserve them as long as possible. The pan is clear plastic and measures roughly 11 inches deep, 22 inches long, and is sold individually.
Fixes these symptoms
Installation Instructions
Rosemarie from Pioneer, CA
renter ruined the crisper drawers and the bottom shelf.
open refrigerator removed old cracked pieces, and cleaned glass self. installed new parts in place. Took less than 5 minutes and it is much better. Read more...
$91.07
In Stock
Refrigerator Water Inlet Valve
★★★★★
★★★★★
2 Reviews
Fix Number FIX7784018
Manufacturer Part Number 242252702
This is a refrigerator water inlet valve and mounting bracket. It is responsible for releasing water from the supply line when triggered, which makes its way through to the water dispenser and/or icemaker in your refrigerator. It is located behind the refrigerator, connected to the water supply. This part is prone to material fatigue from normal use. A defective water valve could cause a lack of ice production, and your water dispenser to stop working properly. If the solenoids no longer have continuity or the valve is plugged, it will need to be replaced. For this repair, you will need to pull the refrigerator out from the wall and disconnect the water and power connection. Please note that this part may look different than the original but is a manufacturer-approved replacement.
Fixes these symptoms
  • Ice maker dispenses too little ice
  • Ice maker not making ice
  • Ice maker won’t dispense ice
  • See more...
Installation Instructions
roger from hubbard, IA
Valve wouldn't fill the ice maker
Old valve used compression fittings on the plastic lines. The new valve uses the push oring fittings which required cutting off the end of each line. The line to the ice maker was quite short to start with and after cutting the end off it was to short which required splicing in a short piece of line. After installation it works fine Read more...
$124.55
In Stock
Refrigerator Door Gasket
Fix Number FIX2331952
Manufacturer Part Number 241872513
The gasket around your refrigerator door is used to make a tight seal when the door is closed, which keeps the cool air inside and the room temperature air outside. If the gasket has become damaged and is not sealing properly, it is important you replace it as soon as possible. Without the tight seal, the fresh food stored in your fridge may not be at the proper temperature, which could result in foodborne illnesses. Replacing the gasket is a simple repair and should not require any tools. You may need a putty knife to loosen up a corner of the old gasket, but otherwise it can be removed by hand. Ensure that the groove is clean of any debris before fitting the new one into place.
Fixes these symptoms
  • Door Sweating
  • Door won’t open or close
  • Fridge and Freezer are too warm
  • See more...
Installation Instructions
Doreen from Fairhope, AL
gasket leaking
Nice to have a groove to accept new gasket. I did better starting with the corners and working toward the centers rather than out from the centers. Read more...
$13.20
In Stock
Crisper Support - Rear
Fix Number FIX2358879
Manufacturer Part Number 241993001
This rear crisper support mounts on the inside of the refrigerator wall to support the rear crisper cover. It is made of white plastic and is sold as an individual part. The support is secured in place by a locking pin. It usually becomes evident that this part needs to be replaced when the shelf is no longer level or the drawer is not opening and closing as it should. For this repair, you will need to remove all the shelves above the crisper to provide space to complete this easy repair. You will need a small putty knife, short flat blade screwdriver, and a small hammer.
Fixes these symptoms
Installation Instructions
Charles from Candler, NC
Crisper support broke causing the crisper to chip on back left corner and the plastic cover broke.
Took hammer and punch pushed the cover pin through, using a putty knife and tape to protect the paint pried the cover support out. pushed the new support in and tapped the pin flush with outside edge of support placed cover back on supports replacing glass. had to order pan-crisper. Every thing came in securely packed and was shipped very quickly. Thank you for the video information on how to remove the broken support. Read more...

Appliance Type

Related Pages

Popular Westinghouse Refrigerator Models