Kenmore Refrigerator Hardware

Kenmore Appliance Parts

Popular Kenmore Refrigerator Hardware

Fix Number
FIX963756
Manufacturer Part Number
WR02X12008
The evaporator fan grommet is used to provide a cushion between the fan motor and the motor mounting bracket in your freezer. This genuine OEM part is about one inch in diameter and is red in color. It is part of the motor assembly found behind the evaporator fan cover at the back of your freezer. If the fan has become quite noisy, it may be time to replace the grommet. To complete this repair, you will need to remove everything from the freezer including the ice tray, the fan cover, freezer floor, evaporator cover, and the fan motor assembly. The tools you will need for this job include a pair of needle nose pliers, a Philips screwdriver and a small flat blade screwdriver, along with a 1/4-inch and a 5/16-inch nut driver. Please ensure that you disconnect the power supply to your fridge before you begin this repair.
Fixes these symptoms
  • Clicking sound
  • Freezer section too warm
  • Fridge too warm
  • See more...
Fix Number
FIX284555
Manufacturer Part Number
WR02X10098
This grommet is found on both the front and back of the fan motor assembly for the condenser and the evaporator in your fridge. It is used to provide a buffer between the fan motor and the mounting bracket, which helps to reduce noise. You may need to replace the grommets if you are getting excessive noise from either the condenser or evaporator fan motors, you may need to replace one or more grommets. This is an authentic OEM part, made of black plastic and measuring approximately 1 inch in diameter. They are sold individually, so if you need to replace more than one grommet be sure to order the correct quantity.
Fixes these symptoms
  • Clicking sound
  • Freezer section too warm
  • Fridge too warm
  • See more...
Screw - Kit of Four
$15.99
In Stock
Fix Number
FIX12365992
Manufacturer Part Number
5304515677
This screw is used to secure the handle to your refrigerator and comes in a pack of four. This genuinely sourced part can be loosened and tightened with a Phillips-head or square-head screwdriver. With the door handle being constantly used, these screws can loosen over time and may eventually wear out, causing the handle to become loose or completely come off. This simple repair should only take a few minutes to complete.
Handle Screw
$9.31
In Stock
★★★★★
★★★★★
1 Review
Fix Number
FIX8752913
Manufacturer Part Number
MJB63190001
This part includes a single mounting bolt needed to secure the door handle to your refrigerator. This part is commonly replaced because the handle has started to loosen. Try tightening the screw first, and if that does not solve the problem, this mounting bolt likely requires replacement. Please note that your handle has a few of these screws and they tend to wear at the same rate, so we recommend having one or two extra on-hand.
Screw
$12.67
In Stock
Fix Number
FIX11757021
Manufacturer Part Number
WPW10661886
This authentic OEM part is a mounting screw for the door handle on your refrigerator. If the door handle is loose or you are having issues opening or closing the door, a new mounting screw may solve these issues. Please note that the screw is sold individually, so if you need to replace more than one you will need to order the appropriate quantity.
Single Washer
$11.15
In Stock
Fix Number
FIX899288
Manufacturer Part Number
240311303
Sold Individually.
Fixes these symptoms
Screw, 8/18 x 3/8
$5.61
In Stock
Fix Number
FIX11746840
Manufacturer Part Number
WP90767
This is a multi-use screw and can be used on a variety of appliances. The measurements of the screw are: 8/18 x 3/8. *Please note: the screw is sold individually. Refer to the manual provided by the manufacturer for further repair guidance.
Compression Ring
$9.84
In Stock
Fix Number
FIX1015726
Manufacturer Part Number
WR02X12149
This OEM compression ring is used to hold the evaporator fan motor in place. Signs that you may need to replace the compression ring are if the fan is noisy, or your fridge or freezer are too warm. We recommend replacing both the compression ring and the evaporator fan grommet at the same time. The evaporator fan motor is found at the back of the freezer compartment, and you will need a Phillips screwdriver to remove the cover concealing the fan. A small flat blade screwdriver may be needed to remove the compression ring from the fan. Please be sure to disconnect the power supply to your fridge before beginning this repair.
Fixes these symptoms
  • Freezer section too warm
  • Fridge too warm
  • Noisy
  • See more...
Screw
$5.61
In Stock
Fix Number
FIX11743743
Manufacturer Part Number
WP681249
Sold individually.
Screw
$12.73
In Stock
Fix Number
FIX428655
Manufacturer Part Number
218755402
10 - 32 x 0.375

Related Kenmore Refrigerator Parts