OEM General Electric Range Hood Parts & Accessories

LIGHT BULB

$49.95

Fix Number: FIX11773829
Manufacturer Part Number: WB25X24863

Improve visibility over the cooktop with a replacement range hood light bulb. A worn bulb may stop lighting, work at times, or appear unusually dim. Check that the bulb is fully seated before replacing it, since vibration can loosen a twist-lock base. If a new bulb does not work, the socket, switch, wiring, or control may require inspection. Verify compatibility using the complete hood model and the electrical rating printed in the owners manual. Turn off the hood and disconnect its power before service. Wait for the bulb and nearby surfaces to cool, handle the replacement carefully, and avoid forcing it into the socket.

CHARCOAL FILTER

$28.91

Fix Number: FIX12716388
Manufacturer Part Number: WB02X32266

This charcoal filter helps improve the air quality in your kitchen by capturing odors and smoke during recirculating operation. Designed as a genuine OEM replacement, it refreshes ventilation performance by absorbing cooking smells and filtering airborne pollutants that accumulate during everyday use. The filter installs easily in compatible range hoods and over-the-range microwaves and should be replaced periodically—typically every six months—to maintain proper airflow and effective odor removal. Verifying your appliance’s model number before purchasing is recommended to ensure the correct fit.

LAMP SOCKET

$32.95

Fix Number: FIX12170321
Manufacturer Part Number: WB18X27245

Range Hood Clip

$19.63

Fix Number: FIX952007
Manufacturer Part Number: WB02X11026

Hold the fan blade or blower wheel firmly on its motor shaft with this small retaining clip. It fits over the shaft after the fan has been placed in position. A secure clip helps keep the fan from sliding or wobbling while it spins. Replacement may be needed if the original clip is bent, cracked, stretched, or missing. Disconnect electrical power and allow the appliance to cool before opening the fan area. Wear work gloves, hold the fan steady, and make sure the new clip is fully seated before testing the motor.

HALOGEN LIGHT BULB

$39.63

Fix Number: FIX16216949
Manufacturer Part Number: WB08X34831

Sold individually.

FILTER CHARCOAL

$58.95

Fix Number: FIX2355813
Manufacturer Part Number: WB06X10807

Freshen kitchen air with a charcoal filter made for an over-the-range microwave in recirculating mode. Measuring about 11 inches long, 2.5 inches high, and 0.7 inches deep, the filter helps collect smoke, fumes, and cooking odors before air returns to the room. It is used when the microwave does not vent outdoors. Charcoal filters are not meant to be washed, so replace the filter when it becomes dirty or odors begin to remain after cooking. Disconnect power before opening the filter area. Follow the owners manual because the access panel and filter position can vary between microwave designs.

Combination Grease and Odor Filter

$38.45

★★★★★

1 Review

Fix Number: FIX223976
Manufacturer Part Number: WB02X10700

It is used for many ranges and vent hoods.

Installation Instructions

Syed from Silver Spring, MD

Filter replacement

No problem Read more...

Light Switch

$19.63

★★★★★

1 Review

Fix Number: FIX953546
Manufacturer Part Number: WB24X10130

This is the replacement light switch for your range. It comes with the actual switch, and the hex nut that goes with it. The switch is approximately 1 ¼ inches by 1 ¼ inches, and the hex nut is approximately ½ an inch in diameter. When you press the switch, it allows you to turn the range light on and off. If the light does not come on when you hit the switch, you may need to replace it. Be sure to disconnect your microwave from the power source before you begin this repair. This part is an authentic OEM part sourced directly from the manufacturer.

Fixes these symptoms

Will Not Start
See more...

Installation Instructions

Thomas from Wildwood Crest, NJ

plastic stems broke replaced both switches

Turn off circuit breaker to vent hood. Note how narrow wire channel cover fits into switch cover underneath hood. Remove range burners and sit on range facing switch cover for access to screws with small Phillips head screwdriver. Remove both back wire cover and switch cover screws. Remove covers. Remove plastic control knobs on front by pulling straight off. Do not twist. With pliers or wrench remove two locking nuts. Light switch has three wires. Fan switch has four. Note wire colors and corresponding numbered slots on back of switch. Using end of large paper clip push into wire slot behind wire to loosen spring tension and carefully pull wire straight out. Do all wires in one switch at a time. Keep wire end straight and insert into correct numbered slot on new switch. Do not overtighten locking nuts upon reassembly. Replace knobs. Screw switch cover back on and then narrow wire cover. Turn circuit breaker on. Test new switches. Read more...

Fan Switch

$21.82

Fix Number: FIX953545
Manufacturer Part Number: WB24X10129

This is the replacement fan switch for your range hood. When you turn the knob to turn the range fan on, the fan switch is actuated. If your fan will not turn on when the knob is turned, you most likely have an issue with the fan switch. The fan has a main square portion with a red center that connects to the fan control knob. The main portion is approximately 1 inch in diameter. This part is sold individually. Be sure to disconnect the power source from your range before you begin this repair.

Installation Instructions

Thomas from Wildwood Crest, NJ

plastic stems broke replaced both switches

Turn off circuit breaker to vent hood. Note how narrow wire channel cover fits into switch cover underneath hood. Remove range burners and sit on range facing switch cover for access to screws with small Phillips head screwdriver. Remove both back wire cover and switch cover screws. Remove covers. Remove plastic control knobs on front by pulling straight off. Do not twist. With pliers or wrench remove two locking nuts. Light switch has three wires. Fan switch has four. Note wire colors and corresponding numbered slots on back of switch. Using end of large paper clip push into wire slot behind wire to loosen spring tension and carefully pull wire straight out. Do all wires in one switch at a time. Keep wire end straight and insert into correct numbered slot on new switch. Do not overtighten locking nuts upon reassembly. Replace knobs. Screw switch cover back on and then narrow wire cover. Turn circuit breaker on. Test new switches. Read more...

Fan Blade

$28.91

★★★★★

1 Review

Fix Number: FIX952006
Manufacturer Part Number: WB02X11025

This part is the replacement fan for your range hood. It is made of white plastic and is approximately 7 inches in diameter. The fan blade helps to dissipate smoke and smells from your range. The main reason you would want to repair the fan blade is if it is damaged, and will not rotate. To remove the fan, use a pair of pliers to grab the retaining clip, and pull the fan blade off the shaft of the motor. This part is sold individually and is an OEM part sourced directly from the manufacturer.

General Electric Range Hood Parts

Popular General Electric Range Hood Parts

Installation Instructions

Installation Instructions

Installation Instructions

General Electric Range Hood Appliance Types

Related General Electric Range Hood Parts

Popular General Electric Range Hood Models

General Electric Range Hood Parts

Start With Your Model Number

Popular General Electric Range Hood Parts

Installation Instructions

Installation Instructions

Installation Instructions

General Electric Range Hood Appliance Types

Related General Electric Range Hood Parts

Popular General Electric Range Hood Models