Dishwasher Caps and Lids

Stop Clip This rail end cap, or dishrack stop clip, is a genuine OEM replacement part for your dishwasher. This part keeps the rack in your dishwasher from sliding out. This is a very easy repair, to complete it you only need a flat blade screwdriver. Use the screwdriver to pry the locking tab open on the cap, located at the front of your upper dishrack. Pull off the end cap and lock the new one into place.

Rinse-Aid Dispenser Cap The rinse aid cap (sometimes referred to as the dispenser cap), covers the rinse aid dispenser on the dishwasher door. If your dishwasher will not dispense detergent, or it is leaking detergent, there could be an issue with the rinse aid cap. Check the cap and its gasket for any damage or melting. If the cap has melted or it is not sealing the dispenser properly, the part should be replaced right away. This rinse aid cap comes with the gasket, so you should discard the existing gasket and rinse aid cap at the same time. The repair is relatively straightforward, and requires no tools.

Rinse Aid Cap This is a replacement cap for the detergent/rinse aid dispenser. If the rinse aid cap is damaged or missing, you may notice too much rinse aid in the dishwasher. The cap simply screws into the dispenser, so if your cap is damaged you can simply screw it out, then screw in the new one. The rinse aid cap is approximately 2 inches in diameter and is sold individually. This is an OEM part, directly from the manufacturer.

Rinse Aid Cap

★★★★★

★★★★★

(1)

This part holds the rinse aid liquid in the dispenser until the timer activates the rinse cycle.

Rinse Aid Cap This cap does not require the use of a o-ring seal.

Rinse Aid Cap This part holds the rinse aid liquid in the dispenser until the timer activates the rinse cycle.

Rinse Aid Cap

★★★★★

★★★★★

(3)

This part holds the rinse aid liquid in the dispenser until the timer activates the rinse cycle.

Rinse Aid Cap This is a replacement cap for the detergent/rinse aid dispenser. If the rinse aid cap is damaged or missing, you may notice too much rinse aid in the dishwasher. The cap simply screws in to the dispenser, so if your cap is damaged you can simply screw it out, then screw in the new one. The rinse aid cap is approximately 2 inches in diameter and is sold individually. This is an OEM part, directly from the manufacturer.

COVER ROLLER Right Hand This part is the replacement roller cover for your dishwasher. It is made of black plastic and is approximately 5 inches by 2 inches. The cover protects the rollers on the dish rack that allow the rack to slide in and out efficiently. The main reason you would need to replace the roller cover is if it is cracked or damaged. This is an authentic OEM part sourced directly from the manufacturer and it is sold individually.

Rinse Aid Cap This rinse aid cap or fill cap is for your dishwasher and it screws into the jet dry dispenser. Sometimes the cap can become loose and fall out, which can cause it to melt from the heater. If your cap is damaged or missing, this is the part you will need to replace it. It is made of white plastic and is a little more than an inch in diameter. This rinse aid cap is sold individually.