Official Crosley Dishwasher Caps and Lids

Stop Clip

$7.28

Fix Number: FIX11770481
Manufacturer Part Number: 5304506510

This rail end cap, or dishrack stop clip, is a genuine OEM replacement part for your dishwasher. This part keeps the rack in your dishwasher from sliding out. This is a very easy repair, to complete it you only need a flat blade screwdriver. Use the screwdriver to pry the locking tab open on the cap, located at the front of your upper dishrack. Pull off the end cap and lock the new one into place.

Watch the install video

Rinse-Aid Dispenser Cap

$27.48

Fix Number: FIX11746426
Manufacturer Part Number: WP8558307

This part includes one OEM rinse aid cap (also known as a dispenser cap), and its purpose is to cover the rinse aid dispenser located on the dishwasher door. Please note that this manufacturer-approved cap has a diameter of 1.42 inches. If the original cap is bigger than that, you may need to replace the entire dispenser assembly. This part is commonly replaced because the dishwasher is not properly dispensing detergent, or it is leaking detergent. Be sure to assess the condition of the rinse aid cap as well as the gasket. This rinse aid cap comes with a gasket, so the old one can be tossed. For this simple DIY repair, open the dishwasher door, turn the old cap a quarter-turn counterclockwise to remove it. Place the new cap in its place and secure it by turning it a quarter-turn clockwise.

Fixes these symptoms

Door latch failure
Leaking
Not cleaning dishes properly
See more...

Watch the install video

Rinse Aid Cap

$19.94

Fix Number: FIX421128
Manufacturer Part Number: 154388801

This is a replacement cap for the detergent/rinse aid dispenser. If the rinse aid cap is damaged or missing, you may notice too much rinse aid in the dishwasher. The cap simply screws into the dispenser, so if your cap is damaged you can simply screw it out, then screw in the new one. The rinse aid cap is approximately 2 inches in diameter and is sold individually. This is an OEM part, directly from the manufacturer.

Fixes these symptoms

Leaking
Not cleaning dishes properly
Not drying dishes properly
See more...

Watch the install video

Rinse Aid Cap

$11.06

Fix Number: FIX11741341
Manufacturer Part Number: WP3378134

This cap does not require the use of a o-ring seal.

Fixes these symptoms

Leaking
Not cleaning dishes properly
Not drying dishes properly
See more...

Shield

$7.80

Fix Number: FIX11753266
Manufacturer Part Number: WPW10343251

Fixes these symptoms

Not drying dishes properly
See more...

Wash Arm Cap

$11.51

Fix Number: FIX11747698
Manufacturer Part Number: WP99002654

This part is the replacement wash arm cap, also known as the spray arm nut, for your dishwasher. It is made of white plastic and is approximately ½ an inch in diameter. The wash arm cap fastens the lower spray arm to the pump housing. If the arm cap is damaged or missing, the arm can wobble or fall off during operation, and this can make it extremely difficult to wash your dishes effectively. To replace the wash arm cap, simply remove it from the spray arm, and replace it with the new cap. This part is an authentic OEM part from the manufacturer, and is sold individually.

Fixes these symptoms