Toro Parts

Fix Number

FIX11804777

Manufacturer Part Number

131-4547-03

This is a genuine OEM replacement blade for use on Lawn Mowers. If the blade is too dull it will tear the grass instead of an even cut. A bent or damaged blade can cause serious damage or injuries. You can use this blade with the Recycler Cutting System to chop grass clippings into fine mulch particles and return them to the ground.

Fix Number

FIX9899150

Manufacturer Part Number

16228-ZL8-000

This is a carburetor gasket and is sold individually. If your engine is running rough, it could be due to a worn or damaged gasket. The gasket is meant to provide an air tight seal, to help protect the engine. This gasket should be replaced when repairing the carburetor. When removing this part, it is advised to clean the surfaces around the carburetor gasket before installing the new one.

Fix Number

FIX9151828

Manufacturer Part Number

795387

★★★★★

★★★★★

1 Review

Fix Number

FIX9048394

Manufacturer Part Number

614426

This is an Original Manufacturer Sourced Stepped Washer used on a variety of Push Lawn Mowers. This is the Metal Washer that fits with Rear or Front Wheel Cover depending on the model. It helps secure the wheel on an Axle with a bolt.

★★★★★

★★★★★

2 Reviews

Fix Number

FIX9903219

Manufacturer Part Number

17211-ZL8-023

To ensure your engine is protected, it is vital that the air filter is inspected regularly and replaced according to the manufacturer recommendations. This filter helps to prevent dirt and dust from making its way into the carburetor and damaging the engine. If the engine is not functioning as it should, this should be one of the first parts you check. To inspect the filter, you will need to remove the air cleaner cover, and lift the filter out of place to remove.

Fix Number

FIX9092936

Manufacturer Part Number

712-04063

This nut is fit for lawn and garden equipment and is used to resist loosening when properly threaded onto a bolt. The nut is sold individually. The diameter of the nut is 5/16 inches and the thread size is 18. Refer to the manual provided by the manufacturer for repair instructions.

Fix Number

FIX16666196

Manufacturer Part Number

144-4805

Fix Number

FIX11804555

Manufacturer Part Number

121-5765

This is a single V-belt for a lawnmower. It is sourced directly from the original manufacturer, ensuring the highest quality replacement part. It measures approximately 1/2-inch wide and 30-1/2-inches long. It is the upper belt off the engine pulley. It goes from the engine drive shaft pulley to the deck, and drives the deck belt. Belts are prone to wear and will need to be replaced periodically.

★★★★★

★★★★★

1 Review

Fix Number

FIX9056413

Manufacturer Part Number

66-7460

Genuine Toro replacement part, this item is sold individually. By pressing the 66-7460 Primer Bulb (a recommended 3-4 times), fuel will be forced from the float bowl into the throat of the carburetor; this will allow the engine of the snowthrower model numbers below to start.

Fix Number

FIX8850145

Manufacturer Part Number

119-2379

This cable-traction is sourced directly from the original equipment manufacturer. It is specially designed for use with Toro lawn mowers. The traction cable engages drive wheels on the equipment. Over time it may wear out or get damaged eventually requiring a replacement. It is connected to the bail and then attached to the traction bracket near the transmission. Refer to the owners manual and the appropriate diagrams of your model for the exact location and the correct installation. One durable rubber insulated cable is included. You may need pliers and a wrench set to disconnect the old part and attach the new one.