Murray Snow Blower Parts

This is a hair pin clip for your lawn equipment. You may also know it as a cotter pin. It is a multi-application part, depending on your unit, as well as the make and model. To correctly install the pin, refer to the diagrams provided with your equipment. It is made of metal, and can be used in various locations in the machine. You will need pliers to install this part.

This nut is mostly used in lawn tractors and snow blowers and is in different locations in the machine, depending on appliance. It is made from metal and measures to 5/16 inches for the diameter and a thread count of 18. Tip: Remember there are different nuts used in the machine, be sure you are ordering the correct part. The tool needed for this repair is a wrench. *Please note: this part is sold individually. Refer to the diagram provided by the manufacturer for instructions.

This hex nut is created for use on lawn and gardening equipment. This is a multi-application nut that depends on the unit and tool you are using. For installation instructions, check the manual provided by the manufacturer. *Please note: this nut is sold individually.

This greased bearing is used on lawn and gardening tools and is sold individually. This part works to reduce friction between rotating parts. This happens when the balls receive the load and spin, which spreads the weight equally whilst the minimal contact area of the part reduces the friction. It is important to repeatedly check for bearings and replace them periodically as they experience constant wear when in operation from pressure, vibration, and heat. For this repair you will need a screwdriver and a set of wrenches. Remember to unplug or turn off power tool before starting this installation project.