DeLonghi Heater Parts
Start With Your Model Number
Find Parts Fast
Guaranteed Fit
Repair Videos
Need help finding your model number?

Popular DeLonghi Heater Parts
Foot Ew6708Ek,
Fix Number FIX10313012
Manufacturer Part Number 7308205800
Installation Instructions
Gary from PALO ALTO, CA
Foot with wheels on my oil/electric heater was broken
U-bolt held on broken foot bracket. Removed the one nut that was holding the old foot on and replaced it with the new foot bracket (which includes the wheels), and fastened it on with u-bolt and nut. Couldn't be simpler -- don't know why I waited so long to fix it.
Read more...
Large Double Rocker Switch 3107/T
2) Open cover panel (containing the switch) with a #2 Phillips screwdriver (one screw).
3) Take a photo of the wires at the switch so you don't forget anything. You could also make a drawing instead.
4) Mark with tape or labels which wire goes where.
5) Gently pull off the wires from the 6 switch connections (do this by hand). They just a push fit connection.
5) Using a flat-head screwdriver, push the plastic tabs holding the switch to the plastic panel insert. It is a little hard to push both top and bottom tabs simultaneously, so you may need two screwdrivers and maybe a second person to help. Just be gentle and don't break anything. Have persistence.
6) Pop out the old switch and pop in the new switch so the tabs click into place. Make sure you get the right side up!
7) Rewire according to your photo and labels. Push the connections down tight.
8) Tighten all the other wire push connections while the cover is open (again, with your fingers).
9) Carefully tuck the wires back inside the cover and connect it back to the heater base and screw the cover screw by hand until you know that it isn't cross-threaded.
10) Use #2 Phillips screwdriver and tighten. Read more...
Fix Number FIX10310270
Manufacturer Part Number 511741
Installation Instructions
Stephen from BERKELEY HTS, NJ
Bad switch
1) Unplug heater and lay on its side on secure surface.2) Open cover panel (containing the switch) with a #2 Phillips screwdriver (one screw).
3) Take a photo of the wires at the switch so you don't forget anything. You could also make a drawing instead.
4) Mark with tape or labels which wire goes where.
5) Gently pull off the wires from the 6 switch connections (do this by hand). They just a push fit connection.
5) Using a flat-head screwdriver, push the plastic tabs holding the switch to the plastic panel insert. It is a little hard to push both top and bottom tabs simultaneously, so you may need two screwdrivers and maybe a second person to help. Just be gentle and don't break anything. Have persistence.
6) Pop out the old switch and pop in the new switch so the tabs click into place. Make sure you get the right side up!
7) Rewire according to your photo and labels. Push the connections down tight.
8) Tighten all the other wire push connections while the cover is open (again, with your fingers).
9) Carefully tuck the wires back inside the cover and connect it back to the heater base and screw the cover screw by hand until you know that it isn't cross-threaded.
10) Use #2 Phillips screwdriver and tighten. Read more...
Switch
Fix Number FIX10310224
Manufacturer Part Number 5110510001
Installation Instructions
steven from ELLICOTT CITY, MD
Switches had broken off
Used pry tool at bottom edge of switch housing existing switch until it came out of front heater cover. Used pliers to completely remove from cover. Swapped wires over to new switch and pushed new switch assembly into front heater cover.
Read more...
Appliance Type
Related Pages
Popular DeLonghi Heater Models
- 3107 Heater
- TRN0812T Heater
- EW6507L Portable Radiator Heater
- 5108T Oil Filled Heater
- 2309K Oil Filled Heater
- EW0507 Oil Filled Radiator
- 3107T Heater
- 9707T Heater
- EW7507EB Heater
- EW0715W Heater
- 9707 Heater
- EW7307K Heater
- TRV0715T Heater
- 5307 Heater
- TRN1015T Heater
- 2507L Heater
- TRH0715L Electric Oil Filter Radiator
- TRD0715T Heater
- 2507 Portable Radiator Heater
- EW7707CM Heater