OEM DeLonghi Parts & Accessories

Generator Gasket - Orange

$7.69

Fix Number: FIX10311182
Manufacturer Part Number: 5332149100

This generator gasket is an OEM quality part that is used to seal the filter to the generator of your coffee maker. If this part is cracked, torn, stretched, or otherwise damaged, it should be replaced. It is made of silicone, is orange in color, has an outside diameter of 43.6mm, inside diameter of 35.2mm, and a thickness of 4.2mm (these measurements are approximate). Sold separately.

O Ring Ec270

$7.41

Fix Number: FIX10310752
Manufacturer Part Number: 5313217701

This is a single O-ring for a coffeemaker/espresso machine. It measures approximately 5/16-inches in outer diameter and has a 3/16-inch inner diameter. This O-ring attaches to the tube, which is connected to the upper boiler. It acts as a water-tight seal to prevent liquid from leaking between these two connected parts. Due to the high temperature and wet conditions, this rubber O-ring is subject to wear and may require replacement.

Water Tank

$43.85

Fix Number: FIX17016539
Manufacturer Part Number: AS13200251

Water Tank

Large Double Rocker Switch 3107/T

$22.35

★★★★★

3 Reviews

Fix Number: FIX10310270
Manufacturer Part Number: 511741

Installation Instructions

Stephen from BERKELEY HTS, NJ

Bad switch

1) Unplug heater and lay on its side on secure surface.
2) Open cover panel (containing the switch) with a #2 Phillips screwdriver (one screw).
3) Take a photo of the wires at the switch so you don't forget anything. You could also make a drawing instead.
4) Mark with tape or labels which wire goes where.
5) Gently pull off the wires from the 6 switch connections (do this by hand). They just a push fit connection.
5) Using a flat-head screwdriver, push the plastic tabs holding the switch to the plastic panel insert. It is a little hard to push both top and bottom tabs simultaneously, so you may need two screwdrivers and maybe a second person to help. Just be gentle and don't break anything. Have persistence.
6) Pop out the old switch and pop in the new switch so the tabs click into place. Make sure you get the right side up!
7) Rewire according to your photo and labels. Push the connections down tight.
8) Tighten all the other wire push connections while the cover is open (again, with your fingers).
9) Carefully tuck the wires back inside the cover and connect it back to the heater base and screw the cover screw by hand until you know that it isn't cross-threaded.
10) Use #2 Phillips screwdriver and tighten. Read more...

Foot Ew6708Ek,

$12.46

★★★★★

1 Review

Fix Number: FIX10313012
Manufacturer Part Number: 7308205800

Installation Instructions

Gary from PALO ALTO, CA

Foot with wheels on my oil/electric heater was broken

U-bolt held on broken foot bracket. Removed the one nut that was holding the old foot on and replaced it with the new foot bracket (which includes the wheels), and fastened it on with u-bolt and nut. Couldn't be simpler -- don't know why I waited so long to fix it. Read more...

O-Ring

$8.32

Fix Number: FIX10310753
Manufacturer Part Number: 5313217751

This is one black rubber O-ring for coffee makers and espresso machines. This O-ring is compatible with various products, however serves the same function. It creates a seal to keep liquids from leaking from the appliance. If your appliance begins to leak, you will want to inspect this O-ring for cracks or breakage.