Whirlpool Dehumidifier Parts

Whirlpool Appliance Parts

Popular Whirlpool Dehumidifier Parts

Compressor Relay and Overload Kit
$91.25
In Stock
Fix Number
FIX371273
Manufacturer Part Number
4387535
The overload protects a motor from overheating and the relay boosts the compressor.
Fixes these symptoms
  • Fridge and Freezer are too warm
  • Fridge too warm
  • Will Not Start
  • See more...

Installation Instructions

Wayne from NEWPORT, WA
Frig quit cooling.
A Sears repairman checked my frig out and determined the Overload Relay (switch) on the side of the compressor was bad (the one piece of the relay with 4 tangs had burned up). The repairman told me that if you take the overload relay off, shake it and there is a rattling noise it has burned up, that was the case here. I ordered part # 4387535 per repairman. There were two wires going to the old relay, one was white the other was red. There are two pieces to the ordered part, one piece with one tang to plug the white wire onto and the other had 4 tangs, labeled 1,2, 3 & 4. As per the repairman the red wire connected to tang #1. The red wire connector would not fit on the new relay tang so I cut it off, stripped the wire and crimped on a bigger connector. The original overload relay fit into a plastic case which would not fit the new relay, I tossed the plastic case and just plugged each piece of the overload relay into the plugs on the side of the compressor, then plugged in the power and it has worked great. Read more...
Water Inlet Hose Washer
$7.95
In Stock
Fix Number
FIX11738697
Manufacturer Part Number
WP16123
Sold Individually. Order quantity needed.
Fixes these symptoms
Float
$8.04
In Stock
Fix Number
FIX11738360
Manufacturer Part Number
WP1172075
Silicone Rubber Adhesive - 2 oz
$51.96
In Stock
Fix Number
FIX11740605
Manufacturer Part Number
WP279368
This is a high temperature adhesive that is used for gaskets and felt seals.
KNOB-CNTRL
$40.73
In Stock
Fix Number
FIX895589
Manufacturer Part Number
1187163

Installation Instructions

Jerry from Mobile, AL
replaced door gasket
I opened the dryer door. applied adhesive..Put the gasket where it belongs. Read more...
Start Relay Combination
$73.26
In Stock
Fix Number
FIX11739983
Manufacturer Part Number
WP2262181
Start relay and overload for production compressor only. The start relay boosts the compressor, and then shuts off as soon as the motor gets up to speed. The overlay provides added protection against excessive current and against excessive temperature use.
Fixes these symptoms
  • Freezer section too warm
  • Fridge too warm
  • Will Not Start
  • See more...
Humidistat Control
$81.09
In Stock
Fix Number
FIX11738359
Manufacturer Part Number
WP1168670
Filter
$44.61
Special Order
Fix Number
FIX11738449
Manufacturer Part Number
WP1188402
Capacitor
$63.77
In Stock
Fix Number
FIX11738454
Manufacturer Part Number
WP1188477
Bucket Water Level Switch
$102.77
In Stock
Fix Number
FIX992307
Manufacturer Part Number
1188814
This part is used to prevent water overflow when the bucket gets full.

Installation Instructions

Bernard from Bridgewater, NJ
Swap out bucket water level switch
The Bucket Water Switch Level Failed. The switch which tells of a fulI water bucket failed the light light would stay on and the dehumidifier would not run even if the bucket was empty.I ordered the part from this site using the model # and manufacturer.Since The part as instock it arrived quickly. To repair/Replace switch first unplug the unit, then unscrew with phillips head screw driver all outer housing screws. The swich is in a plastic holder attached to an inside wall. first label the 3 wires and where they are attached to the switch. Disconnect the wires from the switch.Pinch the switch holder and pull out switch and holder from the front of the unit. The new switch holder is different in my old model so i removed the switch from the new holder and placed it in the old holder. Now slide the new switch back into the unit from the front until it snaps in firmly. Attach the labeled wires to the switch contacts. Place the metal side housing back in place and screw on. Attach the top of the unit by aligning it with the hole on the top of the unit slide it back on the unit it sould lock into place. Plug the unit in and press the little plunger in and the light on top will illuminate and the unit will stop running Read more...

Appliance Type

Related Pages

Popular Whirlpool Dehumidifier Models