Models
>
AD40G1
AD40G1 Whirlpool Dehumidifier
Jump to:
Find Part by Name
Keep searches simple, eg. "belt" or "pump".
Diagrams for AD40G1
Viewing 3 of 3Manuals & Guides for AD40G1
Click to downloadKeep searches simple, eg. "belt" or "pump".
On Order
$5.41
Sold individually. The size of this screw is 1/4" hex head and 10-12 x 1/2".
In Stock
In Stock
In Stock
$102.68
This part is used to prevent water overflow when the bucket gets full.
In Stock
Special Order
Also known as Dehumidifier anti-icing thermostat with clamp.
No Longer Available
In Stock
Questions and Answers
We're sorry, but our Q&A experts are temporarily unavailable.
Please check back later if you still haven't found the answer you need.
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- James from Silver Bay, MN
- Parts Used:
- WP1168670
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
The Origional Humidistat Quit Working
The knob one turns to set the humidity level was removed. The two screws holding the top on were removed. The top was lifted and swung to the side. After noting which of the two wires went where on the humidistat the wires were removed. Small flat screwdrivers were used to pry back the plastic retainers on one side of the original fai
... Read more
led humidistat. The new one was put in place, the two wires were reattached. The knob was replaced. The top was positioned and its two retaining screws replaced. A magnetic phillips screwdriver was handy but not necessary. Piece of cake! Someone with ten thumbs could do it!! Thanks for the prompt courteous attention to the returned erroneous part! Dealing with partselect. Com was a pleasure. . . . . . Thanks!! P. S. The dehumidifier works like new now!!
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Greg from Suches, GA
- Parts Used:
- 1168777
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
Evaporator freeze up
Troubleshoot on the schematic/wiring diagram to find the defective thermostat. Order a replacement part. Remove all outer covers to gain access to the thermostat. Only tool needed for this is a #2 phillips screwdriver. Cut the leads on the defective part and remove thermostat and replace thermostat, wire cutters/crimper required, splice
... Read more
the thermostat leads, Reassemble the outer covers.
Read less
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- larry from tampa, FL
- Parts Used:
- WP1168670
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 15 - 30 mins
- Tools:
- Screw drivers
the humidity control broke
Taking the case apart and replacing the control unit was a piece of cake. And the part arrived the very day after I ordered it.
Was this instruction helpful to you?
Thank you for voting!