Official General Electric Washer Hardware

Watch the install video

Tub Bearing Washer

$9.97

Fix Number: FIX271509
Manufacturer Part Number: WH2X1197

Fixes these symptoms

Leaking
Will not agitate
See more...

Watch the install video

Timer Knob Clip

$11.00

Fix Number: FIX270835
Manufacturer Part Number: WH1X2117

This plastic clip is a genuine OEM part, used to help connect the timer knob to the shaft on your washer. If the clip has become damaged it will need to be replaced. The clip is found on the backside of the timer knob, and if the clip has become damaged the knob may not stay in place or advance through the settings. To do this repair you may need a pair of needle nose pliers to remove the old clip and to ensure the new one is securely in place.

Fixes these symptoms

Touchpad does not respond
Will Not Start
See more...

Watch the install video

Drain Hose Clip

$9.01

Fix Number: FIX270508
Manufacturer Part Number: WH16X513

This clip holds the drain hose to the back of the washer.

Fixes these symptoms

Leaking
See more...

Watch the install video

Hub Washer

$9.20

Fix Number: FIX271511
Manufacturer Part Number: WH2X1199

This is a replacement hub washer for your washing machine. If your washer is noisy, leaking, shaking, or pumping without spinning, you may need to replace the hub washer. The hub washer is found under the washer tub, beneath the split ring. You will need to remove the tub to access it. Before doing so you should disconnect the power and water sources from washer. The washer is made of metal and is a little more than an inch in diameter. It is sold individually, and is an OEM part.

Fixes these symptoms

Leaking
Will not agitate
See more...

Watch the install video

Hub Nut

$21.97

Fix Number: FIX271505
Manufacturer Part Number: WH2X1193

This part is the hub nut, or lock down nut for your washing machine. It is designed to hold the inner tub on to the transmission. If your hub nut is stripped or damaged, it may need to be replaced. This hub nut is approximately 1.5 inches in diameter. This is an OEM part sourced directly from the manufacturer. You will need a hub nut wrench and some WD40 to loosen the nut and remove it from the agitator shaft.

Fixes these symptoms

Leaking
Will not agitate
See more...

Screw 8-16 hxw 1/2 Stainless Steel

$8.54

Fix Number: FIX258461
Manufacturer Part Number: WD02X10067

Sold Individually.

Fixes these symptoms

Noisy
Not cleaning dishes properly
See more...

Screw

$11.21

Fix Number: FIX417463
Manufacturer Part Number: 131302800

This screw is designed to fit washers and dryers. Refer to the diagram provided by the manufacturer for further installation instructions and accurate application of screw in your tool.

Watch the install video

Screw-In Plastic Leveling Leg

$25.94

Fix Number: FIX1152204
Manufacturer Part Number: 134548800

This screw-in plastic leveling leg supports the washing machine. If your washer loses balance while it is tumbling, or makes loud noises, then it is best to replace the leveling leg to make sure the height is adjusted. Refer to the diagram provided by the manufacturer for further installation instructions and safety practices.

Watch the install video