Inglis Refrigerator Thermostats

Bi-Metal Defrost Thermostat

★★★★★

★★★★★

2 Reviews

The bi-metal defrost thermostat is attached to the evaporator, and its purpose is to protect the evaporator from overheating when the defrost cycle is running. If there is frost building up in your freezer, or it gets too warm during the defrost cycle, there may be an issue with the thermostat. You can use a multimeter to determine if it is the thermostat or the heater itself that is faulty. If you do need to replace the thermostat, this is a genuine OEM part. As this repair requires some electrical work, please be sure to disconnect the power supply to your fridge before starting this project. You will need a Phillips screwdriver, a 1/4-inch nut driver, a flat blade screwdriver, wire strippers, electrical tape, and butt splice connectors in order to complete this repair.

Thermostat Assembly

★★★★★

★★★★★

1 Review

This genuine OEM part is a thermostat assembly for your fridge. This part acts as a sensor to detect temperature changes in the evaporator. When the defrost cycle is running and the ice has melted, the thermostat detects the temperature increase and shuts the cycle off. You may need to replace the thermostat assembly if your fridge or freezer is too warm, the temperatures fluctuate constantly, or the units continuously runs, or will not run at all. You can use a multimeter to check if the thermostat is faulty and needs to be replaced. Please be sure to disconnect the power supply to your fridge before beginning this repair.

Thermistor Long harness thermistor kit.

Bimetal Defrost Thermostat This clip-on thermostat will sense the temperature increase in the evaporator during the defrost cycle and will cycle the defrost heater off after the ice or frost is melted.

Damper Control Assembly

★★★★★

★★★★★

1 Review

This part allows the cold air from the freezer section to be aired into the fresh food section and it is controlled by the thermostat.

Defrost Thermostat This is a temperature sensing mechanism. It can sense the rise in evaporator temperature during a defrost cycle and cycles the defrost heater off after all frost is melted from the coils.

Cycling thermostat This part is also known as the cycling thermostat and this bi-metal device controls the activation of the icemaker ejection cycle.

Temperature Control Thermostat This part cycles on and off regularly to keep your refrigerator cold.

Clip-On Bimetal Defrost Thermostat with Leads This part acts as a safety device against over-heating in case of mechanical failure.

Air Diffuser Assembly This air diffuser controls the amount of cold air distributed through the refrigerator.