Official Jenn-Air Range Switches

Range Infinite Burner Switch - 8 Inch

$57.14

Fix Number: FIX11744487
Manufacturer Part Number: WP7403P239-60

This infinite switch for eight inch range burners is almost three inches long. This infinite switch is for 8-inch range burners. When an element is unable to produce any heat on a modern oven, the problem may lie with the infinite switch. This switch is responsible for sending power to the surface elements. Check the element and terminal block to ensure they are working properly. If they are in working order, check the infinite switch at the control panel for any wires that have overheated, or broken terminals to or from the infinite switch. If the infinite switch is damaged or malfunctioning, it will need to be replaced. Remember to unplug your range before beginning this repair.

Fixes these symptoms

Element will not heat
See more...

Dual Surface Burner Switch Kit

$89.03

Fix Number: FIX2003583
Manufacturer Part Number: 12002125

This switch is used to operate the dual surface burner.

Fixes these symptoms

Element will not heat
Will Not Start
See more...

Range Surface Element Control Switch

$154.50

Fix Number: FIX11749818
Manufacturer Part Number: WPW10185286

This surface element control switch is for ranges. Surface element control switch turns the surface element on and off and controls how much heat the element produces. Unplug the range or shut off the house circuit breaker for the range before installing this part. Wear work gloves to protect your hands.

Fixes these symptoms

Element will not heat
See more...

Infinite Switch - 8 Inch

$82.24

Fix Number: FIX11744412
Manufacturer Part Number: WP74010824

Sold individually.

Fixes these symptoms

Element will not heat
See more...

Watch the install video

Dual Surface Burner Switch

$90.75

Fix Number: FIX11744018
Manufacturer Part Number: WP74003122

This part has been updated by the manufacturer. This updated part now has 7 wire terminals instead of 5. The terminals are all labeled, however, the new switch needs to be tested before connecting the pilot lamp wire (P). To test the new switch: 1) Connect the Line Wires (L1 and L2), connect the Load Wires (H1 and H2). 2) Do not connect the pilot lamp (P) wire yet. 3) Reconnect the power to the range and turn on the new switch and one other switch. 4) Connect the leads of a volt meter on L1 of the new switch and P of the other switch you turned on. 5) If the volt meter reads 220V, the L1 and L2 wires on the new switch must be reveresed. 6) Disconnect power, reverse Line Wires if needed and connect the P wire. 7) Reconnect power to the range after reassembly.

Fixes these symptoms