Official Jenn-Air Range Seals and Gaskets

$77.32

Door Gasket

Fix Number FIX11749287

Manufacturer Part Number WPW10162384

This oven door gasket comes with built in retaining clips.

Fixes these symptoms

Door won’t close
Little to no heat when baking
Oven is too hot
See more...

$77.07

Oven Door Gasket

★★★★★

(1)

Fix Number FIX11759723

Manufacturer Part Number W10877014

This part is the replacement door gasket for your oven. It is made of gray rubber and is sold individually. The door gasket runs along the circumference of the oven door and creates a seal that insulates the oven and keeps heat in. If your oven will not heat up properly, or if you notice that the door gasket has become loose or worn, it may need to be replaced. To replace the door gasket, you will need to remove the retaining bracket at the bottom of the oven door, then carefully pull the gasket away from the front of the oven cavity. Then, push the new gasket inside the groove on the outside of the oven cavity, securing it with the arrowhead fasteners that are built in to the oven cavity. This is an OEM part from the manufacturer.

Fixes these symptoms

Door won’t close
Oven not heating evenly
See more...

$54.12

Door Seal

Fix Number FIX11743947

Manufacturer Part Number WP7212P043-60

This door seal is fifty-three inches long. It is all black in color and is made of rubber. There are metallic clips sticking out of this seal at various points. These clips help to secure the seal to range doors.

Fixes these symptoms

Little to no heat when baking
Oven is too hot
Oven not heating evenly
See more...

$87.24

Door Gasket

Fix Number FIX11749288

Manufacturer Part Number WPW10162385

This oven door gasket prevents heat from escaping the oven cavity when in use. It contains all of the attaching clips needed for installation.

Fixes these symptoms

Door won’t close
See more...

$7.76

Brass Seal

Fix Number FIX11744111

Manufacturer Part Number WP74005893

This is the replacement brass seal for your range or cooktop. It is made of brass and is approximately 1 inch in diameter. This part may also be known as the surface burner orifice holder seal. It prevents gas leaks between the surface burner orifice holder and the surface burner head. The main reason to replace this part is if the old seal is damaged or missing, as gas can leak out. It is important that you unplug the range and shut off the gas supply before beginning this repair. This part is sold individually and is an authentic OEM part.