Amana Range Switches

★★★★★

★★★★★

1 Review

Fix Number

FIX11740783

Manufacturer Part Number

WP3149400

If the large surface burner on your range will not heat up, you may need to replace the switch. This genuine OEM switch is used to control the temperature of the large 8-inch burner, along with turning it on and off. Please be sure to disconnect the power supply to your range before beginning this repair, as you will be working with electrical components. When replacing the switch, the electrical harness features slip-on terminals for easy installation and connections to the switch. You should examine the terminals for signs of arcing or corrosion. If these signs are present, the terminals will need to be replaced as well. The shaft for the burner knob may be longer than the switch you just removed, but you will be able to remove the excess length by using a pair of pliers. If you also need to replace the knob used to turn the switch, it can be purchased separately.

★★★★★

★★★★★

1 Review

Fix Number

FIX11754687

Manufacturer Part Number

WPW10434452

This switch controls the stove top surface burner.

Fix Number

FIX11740785

Manufacturer Part Number

WP3149404

This switch controls the stove top 6" surface burner.

★★★★★

★★★★★

1 Review

Fix Number

FIX11744487

Manufacturer Part Number

WP7403P239-60

This infinite switch for eight inch range burners is almost three inches long. This infinite switch is for 8-inch range burners. When an element is unable to produce any heat on a modern oven, the problem may lie with the infinite switch. This switch is responsible for sending power to the surface elements. Check the element and terminal block to ensure they are working properly. If they are in working order, check the infinite switch at the control panel for any wires that have overheated, or broken terminals to or from the infinite switch. If the infinite switch is damaged or malfunctioning, it will need to be replaced. Remember to unplug your range before beginning this repair.

Fix Number

FIX11740774

Manufacturer Part Number

WP3148952

This part carries 5.2-6.6 amps.

Fix Number

FIX12070192

Manufacturer Part Number

W10900107

Fix Number

FIX2003583

Manufacturer Part Number

12002125

This switch is used to operate the dual surface burner.

Fix Number

FIX11744412

Manufacturer Part Number

WP74010824

Sold individually.

Fix Number

FIX11749068

Manufacturer Part Number

WPW10149355

Fix Number

FIX11744018

Manufacturer Part Number

WP74003122

This part has been updated by the manufacturer. This updated part now has 7 wire terminals instead of 5. The terminals are all labeled, however, the new switch needs to be tested before connecting the pilot lamp wire (P). To test the new switch: 1) Connect the Line Wires (L1 and L2), connect the Load Wires (H1 and H2). 2) Do not connect the pilot lamp (P) wire yet. 3) Reconnect the power to the range and turn on the new switch and one other switch. 4) Connect the leads of a volt meter on L1 of the new switch and P of the other switch you turned on. 5) If the volt meter reads 220V, the L1 and L2 wires on the new switch must be reveresed. 6) Disconnect power, reverse Line Wires if needed and connect the P wire. 7) Reconnect power to the range after reassembly.