Shop OEM Dryer Valves

M Series New Style Coil Kit

$28.91

Fix Number: FIX334310
Manufacturer Part Number: 279834

This OEM kit comes with two ignition coils (one three-terminal boost/hold coil, and one two-terminal secondary coil). Usually only one of them burns out, but you should replace them as a set as both have to be operational for the gas valve to open. The primary purpose of the part is to open the gas valve and allow the gas to enter the burner. This is a safety mechanism to make sure that there is never an unsafe buildup of gas inside the appliance. You will find the coils attached to the dryer gas valve. This is not an uncommon repair; it can fail due to normal material fatigue over time. To test your current parts, watch the burner, and if the igniter glows for a while and then shuts off without the gas is igniting, it usually means one of these coils is bad.

Fixes these symptoms

Noisy
Not Heating
See more...

Watch the install video

Water Inlet Valve - Hot

$36.42

★★★★★

2 Reviews

Fix Number: FIX3527427
Manufacturer Part Number: 5220FR2006H

The hot water valve is found at the back of your washer and controls the flow of hot water into the machine. If the valve is defective, the washer may leak, overfill, fill slowly, or not fill with water at all. If this happens the valve should be replaced. There are a couple different methods for testing if your hot water valve is defective. The first is to use a multimeter on the solenoid, the second is to unplug the washer while it is running. If water continues to flow into the machine, then the valve is defective. This genuine OEM part has a standard hose fitting inlet, one water outlet, and measure approximately 3 inches long by 3 inches wide. To complete this repair, you will need to disconnect the water and power supply to your washer and pull it out from the wall so you can access the back panel.

Fixes these symptoms