Roper Dryer Seals and Gaskets

Rear Drum Felt Seal

★★★★★

★★★★★

1 Review

This is a genuine OEM replacement rear drum seal for your dryer. This seal is made of felt and comes with the adhesive required for installation. The purpose of the seal is to prevent hot air from escaping the drum while the dryer is operating. If you notice that it is taking too long for your laundry to dry, that marks are left on your laundry, or the machine is noisy or will not tumble, then you may need to replace the seal.

Door Gasket

★★★★★

★★★★★

2 Reviews

This is a genuine OEM replacement door gasket for your dryer. The gasket, also known as a door seal, is used to provide an airtight seal when the dryer door is closed. If the gasket has failed it can cause hot air to escape the dryer and allow for cooler room temperature air to be sucked in. This causes the dryer to run longer, which means it is less efficient. When replacing this part, we find it easiest to remove the door from the dryer and place it on a suitable work surface. Please note that you will need a high temperature adhesive to attach the gasket to the door, and this glue is not included with the gasket.

Lint Trap Housing Seal This genuine OEM part is a lint trap housing seal for your dryer. This part is used to form an airtight seal at the back of the dryer drum and the lint duct. The foam seal is approximately 28 inches in length, 1 inch wide, about half an inch thick, and has an adhesive backing. The seal is located between the lint duct and the bulkhead of the dryer. You may need to replace the seal if there is air leaking from the dryer while it is running, which would result in your laundry taking too long to dry.

SEAL-DOOR

★★★★★

★★★★★

1 Review

Seal and Bearing This front panel seal kit doesn't include the plastic retainers, reuse the old retainers. No glue is needed, the seal stretches to fit.

Rear Drum Seal with Adhesive Includes high temperature adhesive.

Rear Drum Seal Kit This seal kit for large capacity gas and electric clothes dryers includes a seal, an adhesive, and an instructions sheet. This felt seal for the back of the drum is sewn with red thread.

Bearing and Seal Kit This front bearing and seal kit comes with the adhesive.

Rear Felt Drum Seal with Adhesive Creates a seal between the rear panel and the rear of the drum.

Door Gasket This gray door gasket is used to seal the dryer door when closed. It does not come with the adhesive.