Roper Dishwasher Pumps

Dishwasher Drain Pump If there is still water left in your dishwasher after it has finished running, there may be an issue with your drain pump. The pump is designed to remove water from the tub, and if that is not happening then it could be due to damaged that is causing the motor not to run or a crack causing a leak. If a new pump is required, this is a genuine OEM replacement part. Completing this repair will be easiest if you pull the dishwasher out from under the cabinet. You will need to disconnect both the water and electrical supply to the appliance before starting.

Drain and Wash Impeller Kit

★★★★★

★★★★★

1 Review

This dishwasher drain and wash impeller kit comes with both the drain and wash impeller, gaskets, chopper and installation screw. This part helps stop your dishwasher from leaking and helps with the proper draining of the dishwasher.

Circulation Pump and Motor

★★★★★

★★★★★

1 Review

The part functions by spinning the impeller of the circulation pump, which is used to move the water through the spray arms during the wash cycle.

Accumulator and Filter This part is essential in your dishes getting clean during the wash cycle. If there is any debris or a tear in the filter, it can cause extra buildup and, therefore, causing dirty dishes.

Impeller This is the replacement impeller kit for your dishwasher. This impeller kit comes with 4 pieces, including the impeller and seals which you will need for the repair. The impeller and seal kit is mounted on the dishwasher motor. If your dishwasher is not cleaning dishes properly, it may be an indication that your impeller has gone bad, and you are not getting proper water pressure. If the seals have gone bad, your dishwasher may start to leak. If you are having either of these problems, you may need to replace the impeller kit. Be sure to disconnect the water and power source from the dishwasher before you begin this repair. This is an OEM part sourced directly from the manufacturer.

Sump and Motor Assembly This part moves water up from the sump collection area and up through the spray arms.

Circulation Pump and Motor Assembly

★★★★★

★★★★★

1 Review

*** This part no longer includes the Chopper Assembly as per the Manufacturer *** The part functions by spinning the impeller of the circulation pump, which is used to move the water through the spray arms during the wash cycle.

Drain Pump- 60Hz 120V The drain pump ejects the water from the dishwasher.

Ball, Check

Pump Outlet and Seal