Roper Dishwasher Hardware

Torx Screw 7-18 x 3/4" - sold individually.

Rubber Washer Sold individually. Used with the heating element.

Heating Element Brass Nut This heating element mounting nut is used in dishwashers and is used to hold the nut to prevent leaking. If your nut is damaged or you notice leaking from the dishwasher, then replacing this nut will solve this problem. The tools needed for this repair are a 1/2 inch wrench, 1/4 inch nut driver, and needle nose pliers. To repair, locate the two element heating nuts. Next, disconnect connecter wire and remove nut with wrench. Tip: when installing new nut, remember to add insulator sleeve back on. As a safety precaution, remember to disconnect the water supply line before beginning this installation. Also, unplug your dishwasher from the power source.

Cover Screw This is a multi-use cover screw. It fits appliances such as dryers, ranges, washers, dishwashers, refrigerators, air conditioners, washer dryer combos, freezers, wall ovens, microwaves, dehumidifiers, cooktops, trash compactors, grills, and ice makers. *Please note: This part is sold individually.

Screw - 8-18 x 1/2 Sold Individually.

Screw, 8/18 x 3/8 This is a multi-use screw and can be used on a variety of appliances. The measurements of the screw are: 8/18 x 3/8. *Please note: the screw is sold individually. Refer to the manual provided by the manufacturer for further repair guidance.

Hose Clamp This hose clamp extends from half an inch to an inch in diameter. It is made entirely of metal and is intended for use with Maytag brand washing machines.

Push-In Retainer Clip Sold individually.

Screw Metallic screw that is less than an inch long. Does not include the plastic washer.

Element Grommet Sold individually.