Official General Electric Dishwasher Hoses and Tubes

Watch the install video

CONDUIT MID Assembly

$24.66

Fix Number: FIX6883615
Manufacturer Part Number: WD22X10094

Fixes these symptoms

Not cleaning dishes properly
See more...

CONDUIT MID BLASTER Assembly

$48.01

Fix Number: FIX11729194
Manufacturer Part Number: WD21X20309

Fixes these symptoms

Not cleaning dishes properly
See more...

Pump Filter Coupler

$13.96

Fix Number: FIX1517648
Manufacturer Part Number: WD01X10342

This coupler, also known as a hose connector, is made of white plastic and is about one inch in height, and just over one inch in length. Replacing the coupler is a fairly easy repair. The hardest part of the repair is accessing the spray arm and filter to remove them, in order to replace the coupler. In order to complete this repair, you will need a flat head screwdriver and a 4-inch nut driver.

Fixes these symptoms

Leaking
Not cleaning dishes properly
Not draining
See more...

Watch the install video

Conduit Adapter

$26.48

Fix Number: FIX6883610
Manufacturer Part Number: WD18X10051

This conduit adapter attaches to the central wash arm in your dishwasher to allow the arm to clean dishes thoroughly and properly. This genuine OEM adapter is made of high quality plastic and measures approximately 6 inches long by 4.5 inches wide.

Fixes these symptoms

Not cleaning dishes properly
See more...

Watch the install video

Drain Tube Kit

$34.74

Fix Number: FIX2339994
Manufacturer Part Number: WD24X10045

This kit includes the drain hose with black rubber end fittings and a clamp.

Fixes these symptoms

Leaking
Not draining
See more...

Watch the install video

DRAIN TUBE Assembly

$27.96

Fix Number: FIX6011670
Manufacturer Part Number: WD24X10062

Fixes these symptoms

Leaking
See more...

Drain Hose

$33.97

Fix Number: FIX260686
Manufacturer Part Number: WD24X10014

This drain hose is an OEM, manufacturer-approved replacement part for your dishwasher. The drain hose filters out the wastewater from the dishwasher. If there is a hole in it, water will leak out of your dishwasher. Shut off the water and power to the unit before beginning this repair. Accessing the drain hose involves unscrewing the dishwasher and pulling it out. Remove the clamp holding the hose in place to its connection under the sink, using a 5/16ths socket. Disconnect the fill line. Use a 1/4 inch nut driver to loosen the clamp at the other end of the drain hose. Keep a towel handy for any water still inside. Keep the clamps for use on your new drain hose. Reinstall all hoses and lines in reverse order.

Fixes these symptoms