Select Your Bosch Dishwasher Model

This is a replacement dishrack roller or wheel for your dishwasher. It is made of gray plastic, measures a little over an inch in diameter, and is sold individually. This roller is designed for the lower dishrack of your dishwasher. On one side of the roller is a clip that allows it to be attached to the dishrack. The dishrack roller allows you to slide the dishrack in and out of the dishwasher efficiently. If one of the rollers is broken or missing, it can cause the dishrack to become difficult to slide in and out. To replace the roller, simply snap it off the dishrack, and snap the new one into place. This is a genuine OEM part.

This kit comes with one axle and one roller.

Sold individually.

Sold individually.

This Tine Holder is an authentic OEM replacement part for select dishwashers manufactured by Bosc, Thermador, Kenmore, and Gaggenau. To ensure this will fit your dishwasher, please see the "Model Cross Reference List" below. It is used in the lower rack of a dishwasher, when you select the position you want the tines to be in, this clip holds the tines in place. This clip is designed to hold two tine rows in place. No tools are needed for installation, it simply snaps into place on the dishrack. If your Tine Holder has become damaged, cracked, or lost, it needs to be replaced. This Tine Clip is approximately 1" long, may also be referred to as a Tine Clip, or a Rack Flip Tine Clip, and is sold individually.

The pump ejects the water from the dishwasher through the drain hose.

The dispenser is mounted on the inner panel of the dishwasher door. The cover of the dispenser has a latch mechanism which is controlled by the electronic board or the timer. The latch releases to open and dispense the detergent at the proper time during the cycle.