6EC3FHKXWQ00 Whirlpool Refrigerator - Instructions
Jump to:
Keep searches simple. Use keywords, e.g. "leaking", "pump", "broken" or "fit".
- Customer:
- Michelle from Gig Harbor, WA
- Parts Used:
- WP2223320
- Difficulty Level:
- Easy
- Total Repair Time:
- 15 - 30 mins
Broken tracks
I removed the drawer and shelf from the fridge, then snapped one broken track out. I had to gently pry the track near the middle with a screwdriver to pull out the one small circular tab then the track slid right out. Thankfully I had read some other customer's instructions first so I was not surprised to see the new part had two other small circular tabs that kept it from fitting that I had to file off before snapping the new track in place. I repeated with the other side. It was super easy, I spent more time looking for the file than actually doing the repair! The other reviews were really helpful, without that I would have been more nervous about filing the tabs off the new parts.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- JERRY from LAS VEGAS, NV
- Parts Used:
- WP2223288
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
replaced shelf
pulled old shelf, inserted new one
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Richard from CONYERS, GA
- Parts Used:
- WP2176759
- Difficulty Level:
- Really Easy
- Total Repair Time:
- 1- 2 hours
- Tools:
- Screw drivers
The ice dispenser handle wasn't working properly. Sometime when dispenser handle was pressed it didn't dispense ice on the first try.
I installed a Ice Door Kit. It works Great Now!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Howard from Boynton Beach, FL
- Parts Used:
- 350930
- Difficulty Level:
- Easy
- Total Repair Time:
- 30 - 60 mins
- Tools:
- Nutdriver
Both outside door handles turned very beige
Everything worked perfectly---thanks to the suggestion of your call center agent. She suggested that since the replacement door handles were no longer available, I should consider repainting them--it worked like a charm. Please tell her she was a life saver. We rent that house in Fl and my returning tenants had complained about the discoloring refer handles. Thank you
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- ROBERT from CHANNING, MI
- Parts Used:
- WP2223320
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 30 - 60 mins
slide brkt. meat drawer
The bracket when mfg'ed had plastic molded round (bud like pieces on both ends of new bracket. In order for the bracket to be flush and to fit, I had to saw off the round nubs off. After I did this, the bracket fit without any more problems.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Donna from Huntington, WV
- Parts Used:
- WP2223320
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- 15 - 30 mins
plastic drawer slide track broken
removed the plastic drawer and broken track. New track was the right size, but was difficult to get into place. Wish they wouldn't use plastic for something holding the weight of the drawer plus contents.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Patricia from Akron, OH
- Parts Used:
- 2223308
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
Slide track broke
Removed drawer, removed glass cover, removed slide- reversed. Easy peasy
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Rocky from Downey, ID
- Parts Used:
- WP2223320
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
The Pan slide track on one of the crispers was cracking on the front and letting thr crisper to slide out and fall on the floor,if you would let it
Removed the shelf and brakets Removed the broken sliders from the shelf brackets and replaced them with the new one's from parts select. the new sliders are a tight fit. I used a large screw driver laid side ways and taped on it to seat the sliders into the slots. NIce to have someone help hold the shelf. Reinstall the shelf backing into place. WARNING This is now the time to get out of the kitchen.OH no to late had to help clean the whole thing out and the freezer too. You need to be quick on this one. Do not let her fill the sink with hot soapy water or your doomed Less than a 15 minute job is now an hour AND 15 MINUTE JOB.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Ben from Roseville, CA
- Parts Used:
- WP2223320
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
End of Slide Track Broke Off Other Side Cracked
Used tip of needle nose pliers to release the plastic retaining pin and was able to slide the tracks out. I was able to install one of the new tracks by hand but the other would not slide in place. I had to use some taps with a rubber hammer to start it. I never saw what it was hanging up on, but the hammer did the trick. Were it not for the snag, the install would have taken about two minutes. The bin and sliders are working perfectly.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Richard from Rancho Palos Verdes, CA
- Parts Used:
- WP2223320
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
plastic pan slide tracks broken (both sides)
These are the left & right slide rail tracks for the pull-out meat tray located just under one of the interior shelves. When removing or installing plastic parts you should always use a delicate touch, because plastic is brittle and can crack or break. To install these rails, I used a small screwdriver and a small rubber mallet to lightly tap the old ones off. The new ones I put the tabs in the holes and using the mallet & screwdriver, I lightly tapped into place until I heard a click-lock. So...... use a delicate but forceful approach. Good luck !!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Kissing Oaks from Florahome, FL
- Parts Used:
- WP2223320
- Difficulty Level:
- A Bit Difficult
- Total Repair Time:
- Less than 15 mins
track had two extra lock tabs that had to be ground off
ground off the extra tabs (part had 3 lock tabs; mine had only one). Had to tap the part into place with a hammer; could not install by hand only as the video stated
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- George from Pflugerville, TX
- Parts Used:
- WP2223320
- Difficulty Level:
- Easy
- Total Repair Time:
- Less than 15 mins
tight fit
With a little help of the hammer, I gently tapped the track in place. It wasn't difficult to replace. It was a tight fit, but fit. Thanks again. I will shop this site again for parts.
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- Curtis from Apple Valley, CA
- Parts Used:
- WP2223320
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
Both slide tracks broke on the Snake drawer
Slid off existing tracks and slide new tracks on. One track was a little stubborn to go on, so I put on some utility gloves to get better grip. Your staff are great to work with and the repair items arrived very quickly. Sears was over $10.00 higher per track. Saved a lot of money and got great customer support. Will use your store in the future!
Was this instruction helpful to you?
Thank you for voting!
- Customer:
- P. R. from Bridgeport, WV
- Parts Used:
- WP2223320
- Difficulty Level:
- Really Easy
- Total Repair Time:
- Less than 15 mins
- Tools:
- Screw drivers
Shelf slide bracket broke
Was easy. Great web site. Good picture of part. Received in two days.
Was this instruction helpful to you?
Thank you for voting!