6EC3FHKXWQ00 Whirlpool Refrigerator - Instructions

Removed drawer, removed glass cover, removed slide- reversed. Easy peasy

Apply slight pressure slide broken track back and pull out. Place new track in slots press down and slide forward quick and easy.

Replaced snap in brackets

install took about 5-10 mins and my wife actually did it while I was away. Very easy and cheap (compared to $125 for a new shelf).

removed the plastic drawer and broken track. New track was the right size, but was difficult to get into place. Wish they wouldn't use plastic for something holding the weight of the drawer plus contents.

Took the bad ones off and put the new ones on. Childs play.

I ordered two Whirlpool pan slide tracks, which are identical for the right and left sides. The first track popped right in, just like in the installation video, but the other one got stuck during insertion. I noticed that all three plastic tabs of the track were caught on the edges of their respective metal slots, and the plastic was being shredded by the metal when I pushed harder trying to insert the track. I took a kitchen knife and shaved off small slivers of plastic from the areas of the tabs that were catching. After that, the slide could be inserted easily.

Popped the shelf in place and slid the drawer back in -

It all snapped together just like PartSelect said it would

replaced cam on door. would have replaced mating cam on ref box if i knew there were two pieces.

I first watched the instructional video and from then on it was a simple repair. The Pan Slide Track had been broken, probably from excess weight in the drawer over the past 8 years. After removing the drawer and glass support per the video, I discovered that BOTH the tracks were broken! Fortunately, I had ordered two(2) tracks and was able to replace both in less than 30 minutes. In my experience of do-it-yourself repairs, this was by far the simplest repair do mainly because of the great step by step video.

Nail set was used to push a locking bump to free the old slide. New slide had large bumps on each end which didn't allow tabs to engage mounting.slots on holder. File was used to reduce size of bumps. Original slide had a single bump in the center which fit intro a hole allowing the slide to lock in place securely.

The slide track is designed to slide directly into the slotted metal rails in a no tools required application. However, the tabs in the plastic slide track were slightly bowed inward which decreased the tolerance required to slide freely. After several attempts the plastic then became slightly gouged by the metal rail further preventing the slide track from sliding all the way into place and into the detent. I ended up using a small file to file down the plastic slide track just a bit to remove the gouged plastic and create the required tolerance to allow the slide track to slide into its intended position.

took the shelf out. slid both old side tracks out. new parts had two small plastic nipples on the end of the track that I had to remove. Then the part slid in and it is good as new. Thank You

Approached the repair as described in the video. Removal went very well. On installation the plastic tabs on the slide track were too tight to push into lock position using only hands. Had to use a screw driver and small hammer to tap the slide track into locked position. I regret that I did not replace both tracks at the same time.