66213043K112 Whirlpool Dishwasher - Instructions

Searched YouTube and followed a YouTube video step by step. YouTube had the exact same part replacement instructions. Paper instructions were difficult to read, but YouTube repairman takes you through procedure with closeup video.

Instruction sheet is good but should stress that the thumb pads must face the front side of the dishwasher.

replaced both sides of rack with the new metal parts. easy to do once you realized you what part went where. the instruction pictures could have been bigger or clearer.

Ordered the parts and installed them according to the enclosed instructions & photos that came with the repair parts.

Removed all the old adjuster parts. Laid out new parts for each side. Would have helped if pictures had been better quality. Figured out how the parts would be installed before actually installing them. Almost messed up 2 plastic tabs by not understanding how 2 parts locked together with the tabs and shoved them together too far on the trial run but, was able to get them apart without breaking off the tabs. The new parts are a stronger design than the original. The tracks work like a dream. I rated it a "Bit Difficult" because in the pictures I could not see enough detail, otherwise I would rate it easy.

Remove old parts , installed new

Watched on line video, helped tremendously. The video gave clear concise instructions.

Trial and error

The repair was easy. The replacement parts fit perfectly and the instructions were great.

Dismantled one side of dish rack and rebuilt that side with the new parts and then did the other side. Second side took a lot less time. IT took a while to figure out how to dismantle the old unit as the parts pictures you sent were not too clear in showing the parts.

The instructions that came with the parts do not tell you how to remove the old adjusters from the rack. I found a video on YouTube ( Appliance Video.com) that takes you step by step on how to remove the old parts and how to install the new ones. The video made the repair easy.

Remove old rack adjusters. No removal instructions. Do one at a time. First requires some trial & error until removed. Install new replacement. Instructions not clear because pictures are dark & fuzzy. Again, install one with some trial & error. Second remove & replace becomes very easy.

I disassembled the left side, and installed the new assembly. However, being older and my eyesight not the best, and had assembled it slightly out of position. After adding more light, a magnifying glass. and a much closer look, I found my mistake. I reassembled the unit. The right side only took about ten minutes. I would recommend a larger more visible picture of the unit. I noticed that the units did not roll as easily as the old ones. One must give a slight push to engage the tray into the back of the dishwasher. Had the picture been better, it would have taken only 20 or 30 minutes to assemble.

bought the adjuster kit and the hardest part was taking off the old pieces. the new pieces went on very easily and smoothly. I am a female that has done a lot of house projects and this was not difficult at all.

I removed the old worn parts completely and then, following the instructions and trying to look at the pictures which were very dark and not able to be seen very well, I put the new parts on and replaced the rack in the dishwasher. The repair was fairly simple but would have been easier if the pictures on the instructions had been better.