66213293K112 Kenmore Dishwasher - Instructions

Took old parts off after removing rack. Installed new track adjusters

. This is the second time we have had this defect with this machine. Apparently due to the frequent failures KitchenAid have redesigned the whole adjuster assembly using a mix of materials rather than all plastic. I was therefore supplied two complete assemblies, for which both existing assemblies had first to be removed. The installation instructions supplied with these replacements were not clear, although the text was intelligible. The photographs of the required work as "figures" were however almost unintelligible. The first side took a long time to complete with much trial and error. Once complete this followed as a model for the second side that went much quicker. Most important to watch for the side of the sliders to be outwards since the illustration is wrong. A similar situation exists with the adjustment button and assembly which can be installed in any of four ways, although only one will work. Finally an "errata" insert indicated that a special tool was included in the hardware set for installing the two screws using a Phillips screwdriver; this was not included in my set, although fortunately I had a socket set with this tool included.

Replaced adjustor mechanisms on both sides. Instructions enclosed with the parts kit were pretty much useless - photographs were dark and blurry and not very helpful. Removing the old parts was the most difficult part of the job, and all that the instructions said about that was "remove old parts". I found an excellent video on YouTube by a gentlemen named "Matt" which saved the day; couldn't have done the job without the video.

followed enclosed directions. needed to replace both side as repair parts come as complete set. might add that repair part is stainless steel and easy to work with

Dismantled one side of dish rack and rebuilt that side with the new parts and then did the other side. Second side took a lot less time. IT took a while to figure out how to dismantle the old unit as the parts pictures you sent were not too clear in showing the parts.

tried to follow the instruction that came with the parts, to no avail? it would have been better to send a note that said good luck. the only part that helped was the part that said remove the old parts. after that is was just a fit and test, fit and test, fit and test, only because of my expert analytical abilities was i able to fit it all together. please draw up better instructions. it fits good and works well.

I removed the old worn parts completely and then, following the instructions and trying to look at the pictures which were very dark and not able to be seen very well, I put the new parts on and replaced the rack in the dishwasher. The repair was fairly simple but would have been easier if the pictures on the instructions had been better.

Took a bit of interpretation to figure out how the piece fit together. Not same as the original. Once i decoded the system, the second side took less than 10 minutes. Fits and works fine.

removed old basket adjuster -installed wheel assemble-installed clips to hold wheel assemble installed adjuster on basket installed final adjuster part with screws supplied--instruction photos not clear and to small -first side took about an hour-the second side took ten minutes -parts work great-anyone with common sense can do the repair

Trial and error

I watched this Youtube film: And it was really easy!

bought the adjuster kit and the hardest part was taking off the old pieces. the new pieces went on very easily and smoothly. I am a female that has done a lot of house projects and this was not difficult at all.

You tube feature on the replacement made it a very, very easy job.

Watched instruction video on You Tube. Easy to figure out how old adjuster came off. Followed instructions from video on installation. Did not have proper star screwdriver, but was able to use allen wrench on two screws.

The instructions that were included were a bit scetchy, but we figured it out. I like that the replacement part is made of medal and not plastic. We first put the clips on top then figured out they go below middle bar after that it all came together