66213293K112 Kenmore Dishwasher - Instructions

I removed the old worn parts completely and then, following the instructions and trying to look at the pictures which were very dark and not able to be seen very well, I put the new parts on and replaced the rack in the dishwasher. The repair was fairly simple but would have been easier if the pictures on the instructions had been better.

Took a bit of interpretation to figure out how the piece fit together. Not same as the original. Once i decoded the system, the second side took less than 10 minutes. Fits and works fine.

removed old basket adjuster -installed wheel assemble-installed clips to hold wheel assemble installed adjuster on basket installed final adjuster part with screws supplied--instruction photos not clear and to small -first side took about an hour-the second side took ten minutes -parts work great-anyone with common sense can do the repair

Removed broken adjuster by prying open latch tabs. Assembled replacement per instructions. Had to test fit parts due to poor illustrations, compared to other adjuster for correct installation. 2nd side went much quicker

Watched on line video, helped tremendously. The video gave clear concise instructions.

Remove old rack adjusters. No removal instructions. Do one at a time. First requires some trial & error until removed. Install new replacement. Instructions not clear because pictures are dark & fuzzy. Again, install one with some trial & error. Second remove & replace becomes very easy.

I disassembled the left side, and installed the new assembly. However, being older and my eyesight not the best, and had assembled it slightly out of position. After adding more light, a magnifying glass. and a much closer look, I found my mistake. I reassembled the unit. The right side only took about ten minutes. I would recommend a larger more visible picture of the unit. I noticed that the units did not roll as easily as the old ones. One must give a slight push to engage the tray into the back of the dishwasher. Had the picture been better, it would have taken only 20 or 30 minutes to assemble.

bought the adjuster kit and the hardest part was taking off the old pieces. the new pieces went on very easily and smoothly. I am a female that has done a lot of house projects and this was not difficult at all.

Fairly straightforward install of the kit parts. I was glad to see the new parts were stainless steel and not the weak plastic. I wish I would have known this - I ordered two kits instead of one because I figured it would break again soon. I was very glad to finally find the included screwdriver to torx adapter - I forgot my torx set.

took top rack out and put pieces in

Followed the supplied instructions for the installation of the left and right rack adjuster kit. This is a pretty simple process, however, I suggest to take your time, read the instructions twice if you don't understand it the first time, and look at the pictures carefully because they are rather small. I also installed new drawer tracks. Again, a pretty simple process but make sure you look carefully at the rack stop clip before installing into the track. They are pushed in from the side, and not from the rear as I had first assumed. The front clips come installed on the tracks, and just flip open by 180 degrees so the top basket can be pushed in.

Remove old adjusters, just break them off if necessary since they will be replaced. Then followed the instructions that came with the new kit. They were very good. Took my time on the first side, reading each step in instruction sheet. Second side went much faster, almost didn't need the instruction sheer.

Removed the old broken pieces, and installed the new awesome Stainless steel replacements as directed in the supplied instructions . Inserted the 4 supplied screws and gently tightened them. New parts have been redesigned and are MUCH sturdier than the old plastic parts. Some simple assembly is required.

Followed directions supplied with part. Direction pictures were dark and hard to see details. Hex adaptor for screwdriver was too hard to use because made of plastic. Used my own hex wrench, which gave more leverage to drive screws into plastic pieces.

Followed the installation instructions. Photos on installation instructions were not very easy to see, but instructions were good.