66213293K112 Kenmore Dishwasher - Instructions

The repair was easy: just remove old assembly and replace with new one which was slightly different. The included directions were very poorly printed and practically useless so if you are not somewhat mechanically inclined it would be almost impossible to install just using the instructions provided

I ordered this thinking I would probably need more parts, but was unsure which ones. When the part arrived I immediately noticed that it was not identical to the original part, but looked like it may work. I also received an instruction book that I did not expect. The first side probably took 15 or more minutes. The second side was installed in just a couple minutes. The toughest part was removing the old pieces.

To remove the old parts off the top rack I used a jack knife & a needle nosed plier. The pictures were small in the instructions especially where it showed the small backing plate that held the part that slides up & down. I installed it wrong but I could easily remove it once I pushed in the the tab with a knife blade & then installed it correctly. The updated metal wheels are a big improvement & it works fine now. Huge savings because I did it myself, anyone can do it if you're not in a hurry.

easy - plastic snap in part

The picture of some of the parts for the repair did not match some of the parts received. So new pictures of the most recent parts need to be included in the repair kit. The repair kit only has a few parts, which makes it relatively quick to center and connect. The written instructions were not perfect, especially in identifying which direction the rack adjuster clips need to be oriented, but it was pretty easy to figure out since the clips are well aligned when only put in one way. My son and I connected the right and left rack adjuster wheel assemblies to the upper dish baskets for both dishwashers in about 15 minutes each. That time included taking off the old rack adjuster wheels assemblies and installing and make sure the two new assemblies worked well and fit in the upper water supper valves correctly.

1. Remove the top rack
2. Take a screwdriver and pry off back plastic stop at end of track
3. Slide track off, then slide new track on
4. Take the plastic back stop originally pried off of old track and snap into new track
5. Open plastic stop at front of track
6. Replace top rack.
7. Close plastic stop at from of track
8. Good to go!

They snapped into place very easily no tools required

I used pliers to pull the old clip out and pushed the new one in. Easy as that!!

Popped the old clip out, replaced with new.

Read the instructions, removed old parts, installed the first side in about 4-5 minutes, second side about 3 minutes. Took longer to read instructions, than to repair. This is a great repair package, this appears to be a lot better than original parts. Fast service, very helpful customer service personal for return parts, as I ordered parts I didn't need. Thanks again rob h.

Removed old parts easy. Then used replacement parts and back together again.

Instruction sheet is good but should stress that the thumb pads must face the front side of the dishwasher.

Really went well. Very easy to repair

Removed old adjuster rack from both sides using a screw driver. Followed directions provided with rack adjuster kit and installed new adjuster on both sides.

This was my 4th time replacing these parts. Old parts where all plastic and I was lucky to get 6 months before they all disintegrated from the hot water washing. New parts are steel and replacing the old plastic parts was a piece of cake. Looks and even feels much stronger! Excellent youtube video