OEM Hoover Upright Vacuum Parts & Accessories

Floor Brush

$15.79

Fix Number: FIX12067104
Manufacturer Part Number: H-43414073

This is a genuine OEM part sourced directly from the original manufacturer. This accessory is compatible with all Hoover canisters that have attachments made to fit inside the wand. It features rows of bristles made to agitate the fibers of carpets and upholstery in order to loosen dirt for a thorough clean. This tool is made to lock into place securely and to easily be removed with the press of a button. One nozzle is included.

Agitator Bearing Assembly

$4.15

Fix Number: FIX12067086
Manufacturer Part Number: H-43267002

This is a genuine OEM replacement part sourced directly from Hoover. A bearing is used on each end of the brush roll agitator, allowing it to spin freely. These parts are used to reduce friction and damage between moving parts. They are designed for a high-wear function and are therefore easy to install and replace. This part is sold individually; note that most machines require a pair of bearings.

Brush Carrier

$10.94

Fix Number: FIX12067631
Manufacturer Part Number: H-47318008

Brush Roll Assembly

$18.78

★★★★★

1 Review

Fix Number: FIX12065477
Manufacturer Part Number: H-303202001

This authentic manufacturer approved replacement brush roll assembly is designed for use with Hoover vacuums. The spinning motion of the brush rolls picks up the dust and dirt from the floor. Over time bristles will wear out and would need to be replaced. It is made out of plastic and it is sold individually. When replacing this part you would need a screwdriver. • Remove nozzle plate • Remove old brush roller and snap the new one into place • Secure the access plate

Belt-agitator

$6.02

Fix Number: FIX12066417
Manufacturer Part Number: H-38528008

This is a genuine Hoover vacuum belt. It attaches from the motor drive shaft to the brushroll agitator, spinning it when the lower nozzle is in use. This spinning allows the bristles to disturb the fibers of carpet or upholstery, loosening dirt and debris for a thorough cleaning. This flat style belt attaches to the agitator at the end with a gap in the bristles. It is sold individually. Note that the old belt will appear to be a different size due to stretching from normal use.

Type Y Allergen Paper Bag-3 Pa

$11.69

Fix Number: FIX12066767
Manufacturer Part Number: H-4010100Y

This is a genuine OEM part sourced directly from Hoover. This paper vacuum bag has HEPA (High-Efficiency Particulate Arrestance) filtration, which catches 99.97% of the particles in the suctioned air. This type of bag is not reusable or washable. This listing is for one package of three bags.

Hose Assembly Complete-5.5

$19.17

Fix Number: FIX12067152
Manufacturer Part Number: H-43434223

This is a genuine Hoover stretch-style hose. It is used with vacuums and blowers. This hose has 1-1/4" openings on either end. It is designed to twist lock into place for quick and easy set-up. This assembly includes one stretch hose, one Latch Ring (part # H-36153021), and one Hose Connector (part # H-12593).

Primary Filter

$7.55

Fix Number: FIX12065523
Manufacturer Part Number: H-304087001

This is a genuine Hoover-made filter used in WindTunnel and Elite vacuums. It fits inside of the dirt cup lid. This filter is designed to be rinsable; for best performance, rinse it every two months or if System Check Indicator light is on. Replace it when damaged or when rinsing no longer cleans it. This filter is sold individually. To Clean This Filter: • Hold filter under running water for at least two minutes • Squeeze filter underwater twice • Remove from water; squeeze one more time to remove excess water • Dry filter on edge so that air circulates on both sides • Drying may take up to 48 hours • Allow filter to dry completely before reinstalling

Belt-stretch 2 Pack

$5.20

Fix Number: FIX12068781
Manufacturer Part Number: H-AH20080

This genuine OEM supplied part is specially made for use with Hoover vacuums. The purpose of the belt is to drive the brush roller assembly. It is installed on the shaft of the motor and on the end of the brush roller. It provides an identical replacement for a missing or a faulty component that was installed on a new unit. Please make sure to check the owners manual and the appropriate diagrams of your model for the correct location and application of this part. Keep in mind this high-quality belt is made of durable rubber and is sold individually. NOTE: We do have an article and a video on how to install this belt. Here is the link to it. <u><a href="http://www.ereplacementparts.com/article/4999/How_to_Replace_a_Vacuum_Belt.html">How to Replace a Vacuum Belt </u></a>

Stair And Upholstery Tool

$18.26

Fix Number: FIX12066460
Manufacturer Part Number: H-38613040

This is a genuine Hoover accessory tool made for use with SteamVacs and Upright Extractors. It is made to attach easily to the end of the extractor hose. This part features a row of bristles designed to agitate carpet and upholstery fibers in order to clean more thoroughly. This nozzle tool is sold individually.

Hoover Upright Vacuum Parts

Popular Hoover Upright Vacuum Parts

Hoover Upright Vacuum Appliance Types

Related Hoover Upright Vacuum Parts

Popular Hoover Upright Vacuum Models

Hoover Upright Vacuum Parts

Start With Your Model Number

Popular Hoover Upright Vacuum Parts

Hoover Upright Vacuum Appliance Types

Related Hoover Upright Vacuum Parts

Popular Hoover Upright Vacuum Models