OEM DeLonghi Miscellaneous Parts & Accessories

Grommet

$7.30

Fix Number: FIX10314631
Manufacturer Part Number: SC1092502

Serranda P428(pa) Pm1

$10.45

Fix Number: FIX12020897
Manufacturer Part Number: SC7514300

Pusher&cap Black A950/mg800

$6.25

Fix Number: FIX12020583
Manufacturer Part Number: KW684478

Mounting Bracket

$12.55

Fix Number: FIX10312845
Manufacturer Part Number: 7014002800

Large Double Rocker Switch

$20.95

★★★★★

3 Reviews

Fix Number: FIX10310270
Manufacturer Part Number: 511741

This authentic replacement rocker switch is supplied directly from original manufacturer. It is specially made for use with DeLonghi heaters. It controls the on/off functions of a unit. Switches are commonly replaced parts, over time, mechanical internals will wear out requiring replacement. This plastic switch is sold individually. To complete this repair you will need a screwdriver. • First make sure the tools is not plugged in • Then you want to remove the cover screws • Remove the old switch • Secure the new switch in place • Reassemble and test the unit

Installation Instructions

Stephen from BERKELEY HTS, NJ

Bad switch

1) Unplug heater and lay on its side on secure surface.
2) Open cover panel (containing the switch) with a #2 Phillips screwdriver (one screw).
3) Take a photo of the wires at the switch so you don't forget anything. You could also make a drawing instead.
4) Mark with tape or labels which wire goes where.
5) Gently pull off the wires from the 6 switch connections (do this by hand). They just a push fit connection.
5) Using a flat-head screwdriver, push the plastic tabs holding the switch to the plastic panel insert. It is a little hard to push both top and bottom tabs simultaneously, so you may need two screwdrivers and maybe a second person to help. Just be gentle and don't break anything. Have persistence.
6) Pop out the old switch and pop in the new switch so the tabs click into place. Make sure you get the right side up!
7) Rewire according to your photo and labels. Push the connections down tight.
8) Tighten all the other wire push connections while the cover is open (again, with your fingers).
9) Carefully tuck the wires back inside the cover and connect it back to the heater base and screw the cover screw by hand until you know that it isn't cross-threaded.
10) Use #2 Phillips screwdriver and tighten. Read more...