OEM Troy-Bilt Trimmer Parts & Accessories

Carburetor

$39.54

Fix Number: FIX9119300
Manufacturer Part Number: 753-06190

It is an authentic manufacturer-sourced replacement part that i supplied for Craftsman trimmers. The function of a carburetor is to mix the air and the gas into a highly combustible mix before it goes into the engine, over time components may wear out eventually requiring a replacement to ensure peak performance. It is a high-quality metal body carburetor with included rubber primer bulb, please note this assembly is sold individually. When replacing a carburetor it is advised to replace the gaskets as well to ensure the proper seal, keep in mind gaskets are sold separately.

Fixes these symptoms

Engine stops after a few seconds or minutes
Will Not Start
See more...

Fuel Tank Assembly

$15.20

Fix Number: FIX10009586
Manufacturer Part Number: 753-06183

This is an authentically sourced fuel tank assembly, including the fuel lines, fuel cap, fuel filter, and screws needed for assembly. This fuel tank assembly is for trimmers, and is where the fuel is filtered and stored for use with the engine. Due to its constant contact with fuel, especially if fuel has been left it in for extended periods of time, it may crack, in which case it should be replaced immediately. Leaking gas is very dangerous, so it is important that it get fixed quickly. Before beginning this repair, drain the gas from the tank before installing the new one.

Fixes these symptoms

Will Not Start
See more...

Carburetor O-Ring

$3.99

Fix Number: FIX10009589
Manufacturer Part Number: 753-06185

Watch the install video

Primer and Hose Assembly

$27.42

Fix Number: FIX10014772
Manufacturer Part Number: 791-683974B

This is a primer and hose assembly, and it is used on various lawn equipment. The assembly comes with two parts. The first is the hose which is almost 5 inches long, and less than a 1/4 inch thick. The second part is the primer bulb or primer pump, and that is 2 inches long, and 1 inch wide, with a round bulb head. Together, the primer and hose assembly fill the carburetor with fuel to give your machine a quicker start. After time, your hose will crack and your primer will lose elasticity. Both will have to be replaced when this happens. Before starting this repair make sure to drain the fuel from the tank, and remove the spark plug.

Fixes these symptoms

Will Not Start
See more...

Air Cleaner Gasket

$3.99

Fix Number: FIX10009619
Manufacturer Part Number: 753-06253

Aircleaner Filter

$5.95

Fix Number: FIX10009651
Manufacturer Part Number: 753-06417

Air Filter

$5.95

Fix Number: FIX10014105
Manufacturer Part Number: 791-181757

Bump Head Knob Assembly

$14.78

Fix Number: FIX9306452
Manufacturer Part Number: 791-153066B

This bump knob assembly fits lawn and gardening tools, usually trimmers. This part bumps on the ground to advance the cutting line from the spool. With time and use, this part can wear out easily. It is recommended to order an extra knob assembly to always have on hand. Refer to the manual provided by the manufacturer for installation instructions and safety practices.

Fuel Tank Assembly

$27.40

Fix Number: FIX9118306
Manufacturer Part Number: 753-06250

Watch the install video

Fuel Line and Filter

$20.76

★★★★★

1 Review

Fix Number: FIX10014709
Manufacturer Part Number: 791-682039

This fuel line filters the fuel in the tank as it pushes into the carburetor by the primer bulb. If your carburetor is not getting fuel, ports get clogged, or the fuel line is leaking, then replacing this part will solve these problems. It is important to replace it as soon as damage is noticed because clogging can result in your engine not starting. For this repair, you will need the following tools: torx/Phillips drivers, long screwdriver, long-nosed pliers, long screwdriver, cutters or scissors, and two-cycle engine oil. For this repair, first remove the retainer ring from the fuel line and insert it through gas cap opening. Next, thread the fuel line through the hole in the bottom of the fuel tank and pull the line through to firmly place it against the tank wall. For the last steps, put the retainer ring on the fuel line and press the ring firmly against the external side of the fuel tank wall. Lastly, attach it to correct line on the carburetor.

Fixes these symptoms

Will Not Start
See more...

Troy-Bilt Trimmer Parts

Popular Troy-Bilt Trimmer Parts

Troy-Bilt Trimmer Appliance Types

Related Troy-Bilt Trimmer Parts

Popular Troy-Bilt Trimmer Models

Troy-Bilt Trimmer Parts

Start With Your Model Number

Popular Troy-Bilt Trimmer Parts

Troy-Bilt Trimmer Appliance Types

Related Troy-Bilt Trimmer Parts

Popular Troy-Bilt Trimmer Models