Official Murray Lawn Mower Hardware

Washer Head Screw

$4.13

Fix Number: FIX9982804
Manufacturer Part Number: 584953901

This OEM hex head bolt is for lawn tractors. It is used on mower deck mandrels for mounting the spindles to the deck. This is a self-threading screw and will need to be replaced if it is worn or missing altogether. It is sold individually and is made of metal. You will need a wrench to remove the old screw and tighten the new one.

Lawn Mower Ring Clip

$6.15

Fix Number: FIX9143890
Manufacturer Part Number: 812000029

This manufacturer-approved ring clip is found in various lawn and garden equipment models. A ring clip is used as a fastener that secures components or assemblies onto a shaft or housing (such as part of a mower wheel or steering assembly). When it is installed, the part that is visible acts as a shoulder, holding the specific component or assembly together. This very small metal ring clip (approximately 1-inch by 1-inch) is sold individually.

Lawn Mower Mandrel Spacer Washer

$4.13

Fix Number: FIX9286886
Manufacturer Part Number: 532187690

This is an OEM lawn mower deck mandrel spacer washer, sold individually. It measures approximately 43/64-Inches in diameter, 1-1/8-Inches outer diameter, and 5/32-Inches thick (these measurements are approximate). In general, washers help to spread load, can provide insulation such as electrical, and can also help to prevent galvanic corrosion.

Lawn Mower Hardened Washer

$5.16

Fix Number: FIX9015920
Manufacturer Part Number: 532188967

This is a Genuine Manufacturer Approved replacement washer used on lawn and garden equipment. This part is made out of Metal and is Sold Individually. Washer helps to distribute the pressure evenly over the surface and provides a solid grip.

Lawn Mower Washer

$4.13

Fix Number: FIX9008998
Manufacturer Part Number: 532121749

This is a flat metal washer found in various models of lawn mowers and is sold individually. This flat washer can have various functions depending on the equipment; however, its general purpose is to spread the load under a bolt or screw. It also helps to reduce heat and friction as the fastener is tightened. This repair may require a screwdriver or socket wrench, depending on the fastener for your model. This is a single flat washer; the fasteners are sold separately.

Lawn Mower Flangelock Hex Nut

$6.15

Fix Number: FIX9022497
Manufacturer Part Number: 532409149

This is a genuine hex flange locknut for a lawn mower. It attaches to the carriage bolt (sold separately), fastening the axle assembly braces in place. This part is sold individually, however most models require three. For this repair you will need a wrench set.

Lawn Mower Push Nut

$4.13

Fix Number: FIX9285696
Manufacturer Part Number: 532110452

This is a genuine Craftsman replacement part for use in lawn tractors. It helps to connect the deflector rod to the deflector shield. The metal push nut is a small part and will need to be replaced if it becomes lost or broken. A screwdriver and a set of pliers may be needed to replace this part. This item is sold individually.

Pin-bow Tie Cotter

$4.13

Fix Number: FIX9096195
Manufacturer Part Number: 714-04040

This bow tie cotter pin fits snow blowers, as well as other gardening tools. The pin helps secure the auger to the shaft on a snow blower. Due to constant wear, this is a commonly replaced part. Tip: Extra pins are recommended. *Please note: this part is sold individually. For installation instructions, refer to the diagram provided by the manufacturer.

Lawn Mower Washer

$4.13

Fix Number: FIX9012535
Manufacturer Part Number: 532121748

This part includes one genuinely sourced washer for a ride-on lawn mower. Washers help to disperse the load and provides a tight seal in between components. Depending on your unit, the applications will vary. This metal washer measures approximately 25/32 by 1-5/8 by 16 Ga. You may require a wrench to complete this repair.

Lawn Mower Screw

$5.16

Fix Number: FIX9009676
Manufacturer Part Number: 532137729

This is a single OEM replacement screw for a lawn mower. This flanged hex head screw measures 1/4-20 by 5/8. It is used in various applications, so we recommend checking the diagram related to your model for its exact location.

Murray Lawn Mower Hardware

Popular Murray Lawn Mower Hardware

Related Murray Lawn Mower Parts

Murray Lawn Mower Hardware

Start With Your Model Number

Popular Murray Lawn Mower Hardware

Related Murray Lawn Mower Parts